INFLUENCE OF WATER CONTENT ON CONTENT AND CHARACTERISTIC OF TiO2 DURING PREPARATION OF TiO2 NANOPARTICLES ON SiO2 SURFACE

Ting WANG,Xin JIANG
DOI: https://doi.org/10.3321/j.issn:0454-5648.2005.11.012
2005-01-01
Abstract:TiO2 nano-particles were prepared on an SiO2 surface by the adsorption phase reaction technique, and the influence of water content added on the preparation of TiO2 nano-particles in the adsorption phase nanoreactor was investigated. The changes of Ti content with the reaction time in ethanol bulk during the reaction were determined by spectrophotometry. The results show that the change of Ti content is rapid at the beginning then becomes slow. When the water volume is 1.0-1.1 mL, the Ti content in bulk jump, which is in correspondence to a similar phenomena of the Ti content on the SiO2 surface from energy dispersive X-ray microanalysis. Two different morphologies on the SiO2 surface were observed for TiO2 particles by transmission electron microscopy, i.e. black regions covered the silica, and there were few single particles with f nm in diameter. X-ray diffraction result shows that the grain size of TiO2 particles increases with the increase of water volume. It was found that tetrabutyl tilanate can be hydrolyzed with the water in the adsorption layer and in bulk, as well as the hydroxyl group on the SiO2 surface. The different reaction rates with water and hydroxyl group lead to the different slope in Ti content curves. The hydrolysis reaction of tetrabutyl titanate in ethanol bulk causes a sharp decrease in the Ti content curve.
What problem does this paper attempt to address?