Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Fabrication of Porous Tio2 Film Via Hydrothermal Method and Its Photocatalytic Performances

Controllable Hydrothermal Synthesis, Optical and Photocatalytic Properties of TiO2 Nanostructures

Hydrothermal Preparation Of Nanoporous Tio2 Films With Exposed {001} Facets And Superior Photocatalytic Activity

Fabrication and Photocatalytic Properties of Porous Crystalline Titanium Dioxide Film Co-Doped with Fe and Si by PEO

Fabrication and Photocatalytic Activity of Tio2 Nanofiber Membrane

Porous titania films prepared from interactions of titanium with hydrogen peroxide solution

The Preparation and Chemical Structure of Tio2 Film Photocatalyst Supported on Stainless Steel Using the Sol-Gel Method

A Study of Porous TiO2 Film Photocatalyst and Application on Purification for Enviroment

Room‐Temperature Hydrolysis of Potassium Titanyl Oxalate and Water‐Assisted Crystallization for TiO2 with High Photocatalytic Activity

The Effects of Substrate on the Properties of Sol-Gel Derived TiO2 Films

Controllable Fabrication and Characterization of Porous C/TiO2 Nanocomposite Films As Solar Selective Absorber

Fabrication and Photocatalysis of TiO2 Flower-like Nanostructures

Room-temperature preparation and formation mechanism of porous anatase TiO2 film

Structure and Photocatalytic Properties of TiO2/Perfluorosulfonated Resin Hybrid Films Prepared by Sol-Gel Method

A Preparation Method To Obtain Porous Anatase Tio2 Films At Room Temperature

TiO2 films prepared by DC reactive magnetron sputtering at room temperature: Phase control and photocatalytic properties

Study on Structural, Optical and Hydrophilic Properties of FTO/TiO2 Tandem Thin Film Prepared by Aerosol-Assisted Chemical Vapor Deposition Method

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Structure and Photocatalytic Characteristics of TiO2 Film Photocatalyst Coated on Stainless Steel Webnet

Characterization and Photocatalytic Activity of Tio2 Films Loaded on Different Substrates

Epitaxy of Porous and Photocatalytically Active TiO2 Films at 50°C