Abstract:The elastic properties of 1D nanostructures such as nanowires are often measured experimentally through actuation of the nanowire at its resonance frequency, and then relating the resonance frequency to the elastic stiffness using elementary beam theory. In the present work, we utilize large scale molecular dynamics simulations to report a novel beat phenomenon in [110] oriented Ag nanowires. The beat phenomenon is found to arise from the asymmetry of the lattice spacing in the orthogonal elementary directions of the [110] nanowire,i.e., [-110] and [001] directions, which results in two different principal moments of inertia. Because of this, actuations imposed along any other direction are found to decompose into two orthogonal vibrational components based on the actuation angle relative to these two elementary directions, with this phenomenon being generalizable to <110> FCC nanowires of different materials (Cu, Au, Ni, Pd and Pt).The beat phenomenon is explained using a discrete moment of inertia model based on the hard sphere assumption, the model is utilized to show that surface effects enhance the beat phenomenon, while the effect is reduced with increasing nanowires cross-sectional size or aspect ratio.Most importantly, due to the existence of the beat phenomena, we demonstrate that in resonance experiments only a single frequency component is expected to be observed, particularly when the damping ratio is relatively large or very small.Furthermore, for a large range of actuation angles, the lower frequency is more likely to be detected than the higher one,which implies the experimental predictions of Young's modulus obtained from resonance may in fact be under predictions. The present study therefore has significant implications for experimental interpretations of Young's modulus as obtained via resonance testing.

In situ TEM probing properties of individual one-dimensional nanostructures

In-situ studies of electron field emission of single carbon nanotubes inside the TEM

Beat Phenomena in Metal Nanowires, and Their Implications for Resonance-Based Elastic Property Measurements.

In situ transmission electron microscope studies on one-dimensional nanomaterials: Manipulation, properties and applications

In situ measurements on individual thin carbon nanotubes using nanomanipulators inside a scanning electron microscope

Tuning the Resonance Properties of 2D Carbon Nanotube Networks Towards a Mechanical Resonator

EXPERIMENTAL NANOMECHANICS OF ONE-DIMENSIONAL NANOMATERIALS BY IN SITU MICROSCOPY

In Situ Probing Mechanical Properties of Individual Tungsten Oxide Nanowires Directly Grown on Tungsten Tips Inside Transmission Electron Microscope

In Situmultiproperty Measurements of Individual Nanomaterials in SEM and Correlation with Their Atomic Structures

In situ nanomechanical measurement of Cu nanowires

Electrical, Optical and Ionic Probe Inside Transmission Electron Microscope

In Situ Probing Electrical Response on Bending of ZnO Nanowires Inside Transmission Electron Microscope

In-situ Field Emission Studies of Individual One-Dimensional Nanostructures Based on Scanning Electron Microscope

<i>In situ</i> characterization of the mechanical properties of nanoparticles and nanoscale structures

Electron microscopy and in situ testing of mechanical deformation of carbon nanotubes.

Recent Advances on in Situ SEM Mechanical and Electrical Characterization of Low-Dimensional Nanomaterials.

Fabrication and Electric Measurements of Nanostructures Inside Transmission Electron Microscope

In situ electron microscopy four-point electromechanical characterization of freestanding metallic and semiconducting nanowires

In-Situ Study of Surface Work Function, Electrical Characteristic and Field Emission Property of Individual Zno Nanowire

In situ nanoindentation in the TEM

In Situ Tem Nanomechanics