Abstract:Hardness, activation volume and strain-rate sensitivity of Cu/Cr (face-centered cubic (fcc)/body-centered cubic) and Cu/Zr (fcc/hexagonal close-packed) nanostructured multilayer films have been systematically measured as a function of modulation period (L) and modulation ratio (η), respectively. Significant size effects were found for all the three plastic deformation characteristics, i.e. enhanced hardness and activation volume but reduced strain-rate sensitivity with decreasing the dimension length L. Microstructure evolution was statistically examined to rationalize these size dependences. It was crucially observed that abundant nanotwins existed in the Cu grains, though nanotwin formation was depressed with smaller L. This inverse size-dependent nanotwin formation is responsible for the reduction in strain-rate sensitivity, because the negative effect induced by the decreased nanotwins predominates over the positive effect coming from the raised interfaces/boundaries. A mechanistic model is modified to account for the interface effect as well as the nanotwin effect, which yields calculations of strain-rate sensitivity in broad agreement with the experimental results when L is larger than about 20nm. Below this critical length size, there are discrepancies between the calculations and the experimental results, due to the change in deformation mechanism from dislocation nucleation/slip in confined layers to dislocation crossing interfaces. A confined layer slip model is also modified by considering the nanotwin strengthening to quantitatively describe the L-dependent hardness. In addition, the effects of constituent phases and their relative content on the activation volume and strain-rate sensitivity of NMFs are discussed with regard to variation in η.

Microstructure and flow stress of nanoscale Cu/Nb multilayers

Role of Interfacial Transition Zones in the Fracture of Cu/V Nanolamellar Multilayers

Microstructure and ultrahigh strength of nanoscale Cu/Nb multilayers

Microstructure and mechanical properties of nanoscale Cu/Ni multilayers

Length scale dependent ductility and fracture behavior of Cu/Nb nanostructured metallic multilayers

Effects of size and amorphous layer structure on the strength and plasticity of Cu/CuZr nanolaminates

Tensile deformation and fracture mechanisms of Cu/Nb nanolaminates studied by in situ TEM mechanical tests

Structure-Dependent Size Effects in Cuta/Cu Nanolaminates

Altering Strength and Plastic Deformation Behavior Via Alloying and Laminated Structure in Nanocrystalline Metals

Length-scale-dependent Deformation and Fracture Behavior of Cu/X (x=nb, Zr) Multilayers: the Constraining Effects of the Ductile Phase on the Brittle Phase

Ductility and Fracture Behavior of Cu/Nb Nanostructured Multilayers

A Nanoindentation Study of the Deformation Mode for Nanostructured Ductile/brittle Multilayers: Cracking Versus Shear Banding

Experimental Studies and Modelling of the Deformation Behaviour of Multiple Nanolayers

The Hardness and Related Deformation Mechanisms in Nanoscale Crystalline–amorphous Multilayers

Exploring nanoscale metallic multilayer ta/cu films: Structure and some insights on deformation and strengthening mechanisms

Effect of layer thickness on mechanical properties of Cu/CoCrFeNi nanolaminates: Implications from a quantitative flow stress model

Ultra-high strength and plasticity mediated by partial dislocations and defect networks: Part II: Layer thickness effect

Size-Dependent Deformation Mechanisms and Strain-Rate Sensitivity in Nanostructured Cu/X (X = Cr, Zr) Multilayer Films

Unusual Strain Rate Sensitivity of Nanoscale Amorphous Cuzr/Crystalline Cu Multilayers

Shear strain gradient in Cu/Nb nanolaminates: Strain accommodation and chemical mixing

Mechanical properties of fcc/fcc Cu/Nb nanostructured multilayers