Abstract:In this paper, we propose a novel acquisition system, which can flexibly adjust the sampling rate according to different sampling requirements. First, we propose a sampling model and conduct feasibility verification experiments on it. The experimental results show that the sampling principle has excellent sampling function. Subsequently, we successfully implemented the system. The system combines the differential comparator of FPGA with the characteristics of TDC, which makes full use of the hardware resources of FPGA to realize efficient digital sampling and reconstruction of unknown signals. Among them, the TDC we designed has a time error of less than 100ps at sampling rates lower than 50MSps. the sampled signal is transmitted via Ethernet, and the measured on-chip data link throughput rate reaches 600 Mbps. the sampled information is decoded, fitted and reconstructed in the host computer. In addition, we have thoroughly studied the factors affecting the sampling quality in this acquisition method and summarized the sampling laws after acquiring multiple signals. To ensure the minimum distortion rate, we choose the threshold signal amplitude as 0-5 times of the highest amplitude of the sampled signal, and select the frequency as 10-30 times. Regarding the system resource consumption, the LUT utilization rate is 12.22%, the Slice utilization rate is 23.37%, and the overall design power consumption is 2.094 W. Finally, after a comprehensive evaluation of the performance of the system, the results show that the system has a small error, high precision, and high-speed dynamic sampling function. Synthesizing this paper, the system shows good engineering practicability and feasibility in the field of measurement.

Sampling Clock Design Method Research for Real-Time Spectrum Analyzer's ADC

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

Optimization Of Sample/Hold Circuit For High-Speed And High-Resolution Adcs

Effect on Pseudo Code Ranging Precision by A/D Sampling Clock Jitter

Easy-hardware-implementation Algorithm of Sampling Frequency Synchronization in OFDM Systems

A 10‐MHz to 50‐GHz low‐jitter multiphase clock generator for high‐speed oscilloscope in 0.15‐μm GaAs technology

A Quadrature Clock Generator with Calibration for 22&#x223c;31.4 GS/s Real-Time Sampling System

Analysis and Design of Low-Jitter Clock Driver for Wideband ADC

Design of CMOS Clock Synthesizer for Data Converters

Photonic-Assisted Time-Interleaved Adc Based on Optical Delay Line

A Quadrature PLL with Phase Mismatch Calibration for 32gs/s Time-Interleaved ADC

High-precision time measurement electronics using the bandpass sampling method

A Clock Interpolation Structure Using DLL for Clock Distribution in ADC.

Fully on-chip clock jitter and skew measurement scheme via incoherent subsampling

High precision low-frequency AC signal source for ADC dynamic performance test system

Design of an 8-Channel 40 GS/s 20 mW/Ch Waveform Sampling ASIC in 65 nm CMOS

Waveform Timing Performance of a 5 GS/s Fast Pulse Sampling Module with DRS4

Random Sampling Theory in Samples of UWB Radar Signals

A Power Scalable PLL Frequency Synthesizer for High-Speed Δ—Σ ADC

Dynamic Sample Rate Acquisition System Based on Time-to-digital Converter Technology

A High Speed Sampler for Sub-Sampling IR-UWB Receiver