Abstract:Scan based built-in self-test (BIST), which naturally extends scan-based test methodology with test patterns applied from test equipment to BIST, can be used for the self test of sequential circuits and attain higher fault coverage. If the circuit under test (CUT) contains multiple parallel scan chains, a parallel generator is needed. Known as the common pseudo-random pattern generator (PRPG), an LFSR can be configured to generate a random pattern stream. The PRPG-based patterns may be applied to the existing scan architecture directly from the LFSR, or through some decorrelation logic. In order to attain higher fault coverage, it is very important to analyze the test pattern generation in the scan based BIST. The paper presents a kind of scheme for test pattern generation in the scan based BIST for the circuits with multiple scan chains. In the test pattern generation scheme the PRPG, which is implemented by an LFSR, shifts the sequences into all scan chains simultaneously. The correlativity weight R(M) of multiple scan chains is also defined in the paper. Based on the analysis of the different degree effect on fault coverage due to the different configuration of multiple scan chains, one conclusion is drawn that the probability that the fault coverage is reduced is increased with an increase of the correlativity weight R(M). If the circuit is tested by the multiple scan chains with the minimum R(M), the probability that the fault coverage is reduced is least. In the paper a method to construct multiple scan chains with minimum correlativity weight R(M) is proposed to overcome the bad effect on fault coverage due to the correlation between scan chains. Furthermore the minimum set of deterministic patterns is generated for hard-to-test faults by ATPG and the set is used to design the bit modifying logic circuit (BML), which is located between multiple scan chains and the CUT. Through BML the signals in multiple scan chains are controlled to input to the CUT. When the test control signal is low, the test patterns in multiple scan chains are input into the CUT directly. When the test control signal is high, the value of the signals at certain bit positions in the multiple scan chains are modified by BML and the changed test patterns are input into the CUT to test hard-to-test faults for complete fault coverage. The experiments on some ISCAS'89 benchmark circuits show that the complete fault coverage can be obtained by the test method presented by the paper. The overhead of BML is also analyzed.

Using Weighted Scan Enable Signals to Improve the Effectiveness of Scan-Based BIST

Scan BIST with Biased Scan Test Signals

A Reconfigurable Scan Architecture With Weighted Scan-Enable Signals for Deterministic BIST

Improving Test Quality of Scan-Based BIST by Scan Chain Partitioning

Improving test effectiveness of scan-based BIST by scan chain partitioning

Low-Power Scan-Based Built-In Self-Test Based on Weighted Pseudorandom Test Pattern Generation and Reseeding

Compressing Test Data for Deterministic BIST Using a Reconfigurable Scan Arhcitecture

An Effective BIST Circuit for Barrel Shifter Within 8 Bits MCU

Scan-based BIST using an improved scan forest architecture

BIST Technique Based on the Scan Forest Architecture

A Power Efficient BIST TPG Method on Don't Care Bit Based 2-D Adjusting and Hamming Distance Based 2-D Reordering

Test Pattern Generation in Built-In Self-Test with Multiple Scan Chains

Reduction of test power and data volume in BIST scheme based on scan slice overlapping

Conflict Driven Scan Chain Configuration for High Transition Fault Coverage and Low Test Power

An Novel Solution for Testing Power and Testing Time

A scan chain optimization method for diagnosis

Low-power Weighted Random Pattern Testing

Non-Scan Design For Testability For Synchronous Sequential Circuits Based On Fault-Oriented Conflict Analysis

Scan Chain Configuration Based X-filling for Low Power and High Quality Testing.

Scan Testing for Complete Coverage of Path Delay Faults with Reduced Test Data Volume, Test Application Time, and Hardware Cost

A Cost-Effective Scan Architecture for Scan Testing with Nonscan Test Power and Test Application Cost