Abstract:In a previous work, an ink based on a preceramic polymer, SiC fillers, and chopped carbon fibers was proposed for the production of Ceramic Matrix Composite (CMC) structures by Direct Ink Writing (DIW) and subsequent pyrolysis. Thanks to the shear stresses generated at the nozzle tip during extrusion, carbon fibers can be aligned along the printing direction. Fumed silica was added to the ink in order to enhance its rheological properties; however, the printed structures still showed some deformation in the Z direction. In this work, a second ink was successfully developed to limit deformation and at the same time avoid the addition of fumed silica, which limited the potential temperature of application of the composites. Instead, the positive role of the preceramic polymer on the ink rheology was exploited by increasing its concentration in the ink. Rheological characterization carried out on both inks confirmed that they possessed Bingham shear thinning behavior and fast viscosity recovery. Single filaments with different diameters (~310 µm and ~460 µm) were produced with the latter ink by DIW and subsequent pyrolysis. Tested under a four-point flexural test, the filaments showed a mean flexural strength above 30 MPa, graceful failure, and fiber pull-out. The results of this work suggest that CMC components can effectively be fabricated via DIW of a preceramic ink with embedded short fibers; the preceramic polymer is able to provide the desired rheology for the process and to develop a dense matrix capable of incorporating both fibers and ceramic particles, whereas the fibers addition contributes to an increase of the fracture toughness of the material and to the development of a graceful failure mode.

Direct ink writing 3D printing of graphene/Al2O3 composite ceramics with gradient mechanics

A novel composite binder design for direct ink writing alumina-based ceramics with enhanced strength at low sintering temperature

Direct Ink Writing of Continuous SiO 2 Fiber Reinforced Wave-Transparent Ceramics

Preparation and Mechanical Performance of SiCw/geopolymer Composites Through Direct Ink Writing

Direct 4D printing of gradient structure of ceramics

Optimization of 3D Printing Parameters for Alumina Ceramic Based on the Orthogonal Test

High-performance and high-precision Al2O3 architectures enabled by high-solid-loading, graphene-containing slurries for top-down DLP 3D printing

Microstructure refinement-homogenization and flexural strength improvement of Al2O3 ceramics fabricated by DLP-stereolithography integrated with chemical precipitation coating process

Direct-ink-writing (DIW) 3D printing functional composite materials based on supra-molecular interaction

Microstructure and mechanical properties of continuous carbon fiber-reinforced SiC ceramic composite fabricated by direct ink writing

Direct ink writing of Si2N2O porous ceramic strengthened by directional β-Si3N4 grains

Continuous carbon fiber reinforced ZrB2-SiC composites fabricated by direct ink writing combined with low-temperature hot-pressing

Optimization and Characterization of Preceramic Inks for Direct Ink Writing of Ceramic Matrix Composite Structures

Direct ink writing of 3D piezoelectric ceramics with complex unsupported structures

Recent progress of alumina ceramics by direct ink writing: Ink design, printing and post-processing

UV-Curing Assisted Direct Ink Writing of Dense, Crack-Free, and High-Performance Zirconia-Based Composites With Aligned Alumina Platelets

Mechanical and Dielectric Properties of 3D Printed Highly Porous Ceramics Fabricated Via Stable and Durable Gel Ink

Fabrication of alumina ceramics with functional gradient structures by digital light processing 3D printing technology

Direct ink writing of hierarchically porous Al 2 O 3 matrix composites with enhanced wettability of Al

Preparation of high performance dense Al 2 O 3 ceramics by digital light processing 3D printing technology