Abstract:Li 7 La 3 Zr 2 O 12 (LLZO) garnet-type lithium-ion conductors are being investigated as a promising solid electrolyte for solid-state lithium batteries. To enable a functional all-solid-state configuration intensive investigations are needed to reduce the cathode/electrolyte interfacial resistance which contributes the most to cell performance loss. Among the commercial cathode materials investigated so far, LiCoO 2 (LCO) is one of the most stable with garnet electrolytes as only a superficial reaction has been detected between the two materials. However, even this minor reaction would block the Li-ion transport through the interface, resulting in deteriorated cell performance. In this work, we demonstrate that a thin aluminum oxide layer (5 nm) can be an effective interlayer to impede the formation of a harmful interphase and enable facile Li-ion transfer between LCO and the LLZO garnet. Room-temperature-sputtered LCO thin films were employed to form an interface with the garnet electrolyte and annealed at 800 °C to reveal the effect of the interfacial reaction on the Li-ion transfer across the interface. An aluminum oxide layer was then introduced between LCO and the garnet electrolyte by sputtering a metallic aluminum layer which is then annealed together with the upper LCO layer in oxygen, or by direct atomic layer deposition of the oxide. Compared to the LCO/LLZO/Li cells without an aluminum oxide interlayer, those with the interlayer exhibited improved performance, i.e., a stable discharge capacity of up to 90 mAh/(g LCO) at a C/10 rate, a rate capability up to 1.68C and a stable galvanostatic cycling at 0.1C for over 100 cycles with a discharge capacity fade rate of 0.15% per cycle. It was determined that aluminum diffused into the LCO layer after preventing the initial detrimental reaction between LCO and the LLZO garnet from happening during high temperature annealing, suggesting that the coating does not have to remain a physically blocking layer during cycling to function.

Protective shielding films for atomic-level evaluation of lithium lanthanum zirconium oxide at room temperature

Blocking ion diffusion and minimizing electron charging in solid electrolytes under electron-beam irradiation for transmission electron microscopy analysis

Microscopic Origin of the Ionic Transport Behaviors in Solid Electrolytes for Li Batteries

Reduced Energy Barrier for Li+ Transport Across Grain Boundaries with Amorphous Domains in LLZO Thin Films

Elucidating the Mobility of H+ and Li+ Ions in (Li6.25-Xhxal0.25)la(3)zr(2)o(12)via Correlative Neutron and Electron Spectroscopy

X-ray nanoimaging of crystal defects in single grains of solid-state electrolyte AlxLi7-3xLa3Zr2O12

Lithium Volatilization and Phase Changes during Aluminum-Doped Cubic Li6.25La3Zr2Al0.25O12 (c-LLZO) Processing

A Lithium Intrusion-Blocking Interfacial Shield for Wide-Pressure-Range Solid-State Lithium Metal Batteries

Blocking lithium dendrite growth in solid-state batteries with an ultrathin amorphous Li-La-Zr-O solid electrolyte

Interrelationships among Grain Size, Surface Composition, Air Stability, and Interfacial Resistance of Al-Substituted Li7La3Zr2O12 Solid Electrolytes

Isomeric Li–La–Zr–O Amorphous–Crystalline Composite Thin-Film Electrolytes for All-Solid-State Lithium Batteries

Improving the Ionic Conductivity of the LLZO–LZO Thin Film through Indium Doping

Atomic-Resolution Electron Microscopy Unravelling the Role of Unusual Asymmetric Twin Boundaries in the Electron-Beam-Sensitive NASICON-Type Solid Electrolyte.

All-Solid-State Rechargeable Thin Film Lithium Batteries With Lixmn2o4 And Lixmn2o4-0.5zro(2) Cathodes

Removal and Reoccurrence of LLZTO Surface Contaminants under Glovebox Conditions

Exploring the influence of focused ion beam processing and scanning electron microscopy imaging on solid-state electrolytes

All Solid-State Li/LLZO/LCO Battery Enabled by Alumina Interfacial Coating

Atomic Structure of a Lithium-Rich Layered Oxide Material for Lithium-Ion Batteries: Evidence of a Solid Solution

Dynamic Shielding of Electrified Interface Enables High-Voltage Lithium Batteries

Elucidating the Importance of Quaternary Dopants in Stabilizing Cubic LLZO at Low Temperature

Imaging the microstructure of lithium and sodium metal in anode-free solid-state batteries using electron backscatter diffraction