Abstract:The thermo-chemical conversion of biomass wastes is a practical approach for the value-added reclamation of bioenergy in large quantities, and pyrolysis plays a core role in this process. In this work, poplar (PR) and cedar (CR) were used as staple wood biomasses to investigate the apparent kinetics of TG/DTG at different heating rates. Secondly, miscellaneous wood chips (MWC), in which PR and CR were mixed in equal proportion, were subjected to comprehensive investigations on their pyrolysis behavior and product evolution in a fixed bed reactor with pyrolysis temperature, catalyst, and the flow rate H2O steam as influencing factors. The results demonstrated that both PR and CR underwent three consecutive pyrolysis stages, the TG/DTG curves shifted to higher temperatures, and the peak temperature intervals also enhanced as the heating rate increased. The kinetic compensation effect expression and apparent reaction kinetic model of CR and PR pyrolysis were obtained based on the law of mass action and the Arrhenius equation; the reaction kinetic parameter averages of Ea and A of its were almost the same, which were about 72.38 kJ/mol and 72.36 kJ/mol and 1147.11 min−1 and 1144.39 min−1, respectively. The high temperature was beneficial for the promotion of the pyrolysis of biomass, increased pyrolysis gas yield, and reduced tar yield. This process was strengthened in the presence of the catalyst, thus significantly increasing the yield of hydrogen-rich gas to 117.9 mL/g-biomass. It was observed that H2O steam was the most effective activator for providing a hydrogen source for the whole reaction process, promoted the reaction to proceed in the opposite direction of H2O steam participation, and was beneficial to the production of H2 and other hydrocarbons. In particular, when the flow rate of H2O steam was 1 mL/min, the gas yield and hydrogen conversion were 76.94% and 15.90%, and the H2/CO was 2.07. The yields of H2, CO, and CO2 in the gas formation were significantly increased to 107.35 mL/g-biomass, 53.70 mL/g-biomass, and 99.31 mL/g-biomass, respectively. Therefore, H2 was the most dominant species among gas products, followed by C-O bond-containing species, which provides a method for the production of hydrogen-rich gas and also provides ideas for compensating or partially replacing the fossil raw material for hydrogen production.

Mechanistic Analysis of Hydrogen-Rich Co-Gasification of Pine Wood and Polypropylene-Based Waste Masks Using Fe/Dol Catalyst

Analysis on low-temperature polyethylene pyrolysis and gasification in different atmospheres

Valorizing disposable face masks into non-condensable hydrocarbon gases via optimal reactor configurations in thermal pyrolysis

Co-pyrolysis characteristics and synergistic effects of masks and peanut shells in the preparation of light aromatic hydrocarbons under catalyst

A Study on the Pyrolysis Behavior and Product Evolution of Typical Wood Biomass to Hydrogen-Rich Gas Catalyzed by the Ni-Fe/HZSM-5 Catalyst

Co-hydropyrolysis of Pine and HDPE over Bimetallic Catalysts: Efficient BTEX Production and Process Mechanism Analysis

Two Birds with One Stone: High-Quality Utilization of COVID-19 Waste Masks into Bio-Oil, Pyrolytic Gas, and Eco-Friendly Biochar with Adsorption Applications

Catalytic co-pyrolysis of poplar tree and polystyrene with HZSM-5 and Fe/HZSM-5 for production of light aromatic hydrocarbons

The Removal of Tar and the Production of Methane-Rich Gas from Biomass Hydrogen Pyrolysis by Using Biochar-Based Catalysts

Syngas Production from Protective Face Masks through Pyrolysis/Steam Gasification

Co-pyrolysis of heavy bio-oil and disposable masks pyrolysate with Ce/Fe-based oxygen carrier catalyst

Biochar-advanced thermocatalytic salvaging of the waste disposable mask with the production of hydrogen and mono-aromatic hydrocarbons

Microscopic mechanism for CO 2 -assisted co-gasification of polyethylene and softwood lignin: A reactive force field molecular dynamics study

Effect of Fe impregnation on CO 2 -assisted pyrolysis of hazelnut shell

H2-rich gas production from wood biomass air-steam gasification over a multifunctional Ni1.5Ca4.0Mn1.0Ox catalyst derived from biomaterial

Catalytic co-gasification optimization of biomass and polyethylene wastes in oxygen-rich environments

Preparation of monocyclic aromatic hydrocarbons from industrial lignin residue and polyethylene co-pyrolysis by microwave-assisted in fluidized bed based on bimetal-loaded HZSM-5/MCM-41 core-shell catalyst

Hydrogen-rich gas production from disposable COVID-19 mask by steam gasification

Co-gasification characteristics of Ca-rich sludge and Fe-rich sludge under CO2 atmosphere, and potential utilization of gasification residues as renewable catalyst in biomass pyrolysis

Synergistic Effects of Fe@C Catalysts Prepared at Different Carbonization Temperatures on Microwave Co-Pyrolysis of Biomass and Plastic for High-Value Oil and Gas Production

Revealing the mechanism on steam co-gasification of cellulose and polyethylene: A combined ReaxFF and DFT study