Abstract:Water lubricated stern bearings (WLSBs) are the critical component of ship propulsion system and have important effect on navigation safety. Operating temperature plays a main role on the performance of WLSBs. This paper aims to investigate the effect of operating conditions on bearing temperature characteristics under hydrodynamic lubrication. A novel CFD simulation method developed to improve calculation accuracy. Finite difference method was used to decrease the error of geometric modeling while the experiment and experimental correction formula were exploited to obtain improved boundary conditions. Based on the new method, the effects of operating conditions on temperature characteristics for two typical WLSBs were studied, and mechanisms of bearing temperature field evolution were discussed. Results show that the max friction coefficient appears when bearings are in low velocity and low load condition. Total heat flux density is a function of linear velocity, pressure and friction coefficient. Max temperature of bearing at 0.4 MPa decrease along with increased velocity, while decrease first and then increase at 0.2 MPa. Moreover, peak temperature appears at eccentric side and beyond minimum water film thickness position about 4–40°. High temperature area mainly located at the position of 80–140° in circumferential direction and 0.2–0.13 m in axial direction. With the increase of inlet water velocity, the max temperature of bearing changes slightly. It is appropriate to set the inlet velocity at 2 m/s to obtain better cooling performance. This work can provide theoretical basis for the operation monitoring of WLSBs and the development of new materials.

Influence of sea wave shock on transient start-up performance of water-lubricated bearing

Dynamic Mixed Lubrication Investigation of Water-Lubricated Bearing With Unbalanced Rotor During Start-Up

Influence of squeezing and interface slippage on the performance of water-lubricated tilting-pad thrust bearing during start-up and shutdown

Shock Response Analysis of a Ship Power Shafting System

Simulation and experimental investigations on water-lubricated squeeze film damping stern bearing

The Friction-Induced Vibration of Water-Lubricated Rubber Bearings during the Shutdown Process

Modelling and theoretical research on transient lubrication and wear coupling behavior of main bearing during start-up of low-speed diesel engine

A new tribo-dynamics modeling and online measurement method for crosshead bearings in marine engines

Transient nonlinear dynamics of the rotor system supported by low viscosity lubricated bearing

Five-DOF nonlinear tribo-dynamic analysis for coupled bearings during start-up

Transient tribo-dynamic analysis of crosshead slipper in low-speed marine diesel engines during engine startup

Theoretical and experimental study on the fluid-structure-acoustic coupling dynamics of a new water lubricated bearing

Effects of the Stiffness of Vibration Isolators on Anti-shock Dynamics for Propulsive Shafting of Ship

Effects of Initial Conditions and Impact Load on Transient Lubrication Behavior of Journal Bearings

A novel approach to investigate temperature field evolution of water lubricated stern bearings (WLSBs) under hydrodynamic lubrication

Transient dynamic analysis and experimental verification on lubrication regime transition during startup period of non-contacting mechanical seal in liquid oxygen turbopump

Vibration Reduction Performance of Damping-Enhanced Water-Lubricated Bearing Using Fluid-Saturated Perforated Slabs

Transient Thermo-Elasto-hydrodynamic Analysis of a Bidirectional Thrust Bearing in Start-Up and Shutdown Processes

Effects of turbulence and bush wear on the transient tribo-dynamic characteristics of water-lubricated bearings

Study on the wear characteristics of hydrodynamic seals during start-up based on cross-scale contact mechanics

Numerical analysis on the dynamic behavior of the water-lubricated bearing of the energy recovery turbocharger during start-up