Abstract:Heat transfer analysis for the compression hydrogen storage tank (CHST) during the charge–discharge cycle is necessary to ensure quick and safe refueling for fuel cell vehicles. In this paper, a dual‐zone dual‐temperature (DZDT) model for a CHST during the charge–discharge cycle process is established. The constant/variable mass flow rates and heat transfer coefficients (HTCs) are combined to form three methods. Method 1 uses constant mass flow rate and constant HTC. Method 2 uses variable mass flow rate and variable HTC calculated through the energy conservation equation. Method 3 uses variable mass flow rate and variable HTC calculated through the empirical equation. Then, these methods are applied to the DZDT model for heat transfer analysis in three cases. Research shows that for the charging process, the simulated hydrogen temperatures by Method 2 agree well with experiment data for three CHSTs. Method 1 has a maximum error of about 20°C for 19 L CHST, 15°C for 29 L CHST, and 25°C for 40 L CHST. The error of Method 3 is between Methods 1 and 2. The simulated hydrogen pressures by Methods 2 and 3 agree well with the experimental data, while Method 1 has a maximum error of about 5 MPa for 19 L CHST, 10 MPa for 29 L CHST, and 3 MPa for 40 L CHST. For the discharge process, the simulated hydrogen temperatures by Methods 2 and 3 have a relatively slight difference with the experimental data, while Method 1 has relatively significant differences for three CHSTs. Only slight differences exist between the simulated hydrogen pressures by Methods 1, 2, and 3 with the experimental data for three CHSTs. In short, Method 2 can simulate the hydrogen temperature and pressure well during the charge–discharge process. Method 3 can simulate the approximate hydrogen temperature and precise hydrogen pressure during the charge–discharge process. Method 1 can only simulate the hydrogen pressure during the discharging process. The conclusions of this article can inform researchers which analysis methods are more reasonable to choose in future hydrogen‐filling studies.

Improvement of MC method in SAE J2601 hydrogen refuelling protocol using dual-zone dual-temperature model

Optimal estimation of MC parameter in SAE J2601 hydrogen refuelling protocol based on modified formula and artificial neural networks

Lumped Parameter Modeling of SAE J2601 Hydrogen Fueling Tests

Numerical Modeling for Rapid Charging of Hydrogen Gas Vessel in Fuel Cell Vehicle

Thermodynamic and heat transfer models for refueling hydrogen vehicles: Formulation, validation and application

Thermodynamic modeling and analysis of cascade hydrogen refuelling with three-stage pressure and temperature for heavy-duty fuel cell vehicles

A numerical study on the thermal behavior of high pressure hydrogen in the on-board storage cylinder

Numerical Analysis of Temperature Rise Within 70 MPa Composite Hydrogen Vehicle Cylinder During Fast Refueling

Towards fast and safe hydrogen filling for the fuel vehicle: A variable mass flow filling strategy based on a real-time thermodynamic model

Thermodynamic modeling and analysis of hydrogen storage systems in hydrogen refueling stations

Heat Transfer Analysis Methodology for Compression Hydrogen Storage Tank during Charge–Discharge Cycle

Parametric study of hydrogen filling process in type IV tank based on CFD simulation

Quantitative molarity Control-Based method (MCBM) for use with untethered hydrogen fuel system

Creation and validation of a dynamic simulation method for the whole process of a hydrogen refueling station

A two-phase non-isothermal mixed-domain PEM fuel cell model and its application to two-dimensional simulations

Experimental and Numerical Study on Temperature Rise Within a 70 MPa Type III Cylinder During Fast Refueling

A Study on the Thermal Behavior of Series and Parallel Connection Methods in the Process of Hydrogenation of Ship-Borne Hydrogen Storage Cylinder

Numerical simulation of temperature rise within hydrogen vehicle cylinder during refueling

Online Systemic Energy Management Strategy of Fuel Cell System with Efficiency Enhancement

Experimental and Numerical Research on Temperature Evolution during the Fast-Filling Process of a Type III Hydrogen Tank

A Multidisciplinary Design Method and Application for Complex Systems