Abstract:Compression is currently the preferred storage technology for hydrogen vehicles due to its quick refueling process and relatively simple design. However, the temperature rise associated with fast filling must be controlled to ensure its safe operation. This article discusses general heat transfer models based on the mass and energy balance equations for the refueling process of the compressed hydrogen storage tank. Depending on the way of treating the geometric structure of the storage tank, three general lumped parameter models of single-zone (hydrogen), dual-zone (hydrogen and tank wall) and triple-zone (hydrogen, tank wall liner and shell) are built. The general single-zone and dual-zone models are reduced to some special cases which have been published. Under adiabatic and diathermic conditions, four models, including single-zone, dual-zone single-temperature (hydrogen temperature), dual-zone dual-temperature (hydrogen and tank wall temperatures) and triple-zone triple-temperature (hydrogen, tank wall liner and tank wall shell temperatures), are implemented using Matlab/SimulinkTM to simulate the hydrogen refueling process under corresponding conditions. Analytical solutions of single-zone and dual-zone lumped parameter models are derived. The temperature rises of the compressed hydrogen storage tank are described by comparing the analytical solution with the numerical solution. The proposed general models were applied to estimate the final hydrogen temperature and mass, the SOC, the refueling time, and the precooling hydrogen temperature, reviewed and summarized in this article. The analytical solutions of the heat transfer during hydrogen refueling can provide theoretical guidance for improving the refueling efficiency and enhancing refueling safety.

Numerical simulation of temperature rise within hydrogen vehicle cylinder during refueling

Numerical Analysis of Temperature Rise Within 70 MPa Composite Hydrogen Vehicle Cylinder During Fast Refueling

Numerical Simulation on the Temperature Rise of Natural Gas Storage Cylinders during Refueling

Thermodynamic and heat transfer models for refueling hydrogen vehicles: Formulation, validation and application

Experimental and Numerical Study on Temperature Rise Within a 70 MPa Type III Cylinder During Fast Refueling

Numerical Modeling for Rapid Charging of Hydrogen Gas Vessel in Fuel Cell Vehicle

Numerical Study of Hydrogen Leakage and Explosion in Hydrogen Refueling Station with Large Volume Hydrogen Storage Vessels

Experimental Studies on Temperature Rise Within A Hydrogen Cylinder During Refueling

Experimental and Numerical Research on Temperature Evolution during the Fast-Filling Process of a Type III Hydrogen Tank

Numerical Simulation on the Leakage and Diffusion of Hydrogen in Indoor Environment

Numerical Simulation of Gases over Flat Plate Using Two-Temperature Nonlinear Coupled Constitutive Relations

A numerical study on the thermal behavior of high pressure hydrogen in the on-board storage cylinder

Numerical Study on Fast Filling of 70 MPa Type III Cylinder for Hydrogen Vehicle

Research on control of temperature rise in fast filling of composite high pressure hydrogen cylinders

Numerical Analysis of Hydrogen Behavior Inside Hydrogen Storage Cylinders under Rapid Refueling Conditions Based on Different Shapes of Hydrogen Inlet Ports

Thermo-mechanical Investigation of Composite High-Pressure Hydrogen Storage Cylinder During Fast Filling

Thermal Models for Self-Pressurization Prediction of Liquid Hydrogen Tanks: Formulation, Validation, Assessment, and Prospects

Dynamic Thermal Performance of Cryogenic Liquid Hydrogen Heating from Gas-Liquid Stratification to Supercritical under a Constant Heat Flux Condition: A Two-Step Simulation

Towards fast and safe hydrogen filling for the fuel vehicle: A variable mass flow filling strategy based on a real-time thermodynamic model

Comparative analysis of CFD models to simulate temperature non-uniformity during hydrogen tank refuelling

Parametric study of hydrogen filling process in type IV tank based on CFD simulation