Abstract:Hot rolling of steels represents one of the most critical steps to achieve finished products with high surface quality. The increasing productivity added to the rising customer requirements result in more and more severe scheduling rules for the HSM. Strip surface aspect is very important in terms of HSM operation costs and productivity limitation. Among all surface defects, the most crippling comes from the oxide scale formed at the surface of the steel during the hot rolling, at the entry of the finishing mill (last part of the hot strip mill): the secondary scale, mechanical behaviour of which is still poorly known. The secondary scale may fracture under the stresses imposed by the successive rolling passes, and can be embedded in the steel strip surface: this defect is called "rolled-in scale defect". In addition, the extrusion of the subjacent metal inside the oxide cracks induces large local modifications of friction and heat transfer conditions. Consequently, a precise description of oxide scale deformation mechanisms is necessary to better define the boundary conditions in a roll bite and to better understand the initiation mechanisms of rolled-in scale defects. Our scientific objective is then to provide a realistic physical and numerical model to simulate the oxide scale flow in the roll bite and in particular, its damage. After the presentation of the industrial process and the context of this study, the physical and mechanical properties of the oxide scale in the finishing mill are investigated. We introduce the Forge2® finite element software, selected for this study to simulate the oxide scale behaviour in a finishing mill stand. The numerical developments performed to simulate the different kinds of oxide damage are described. Three mechanical tests have been selected to approach the solicitations undergone by the oxide scale at the entry of the roll gap, suspected to be critical for damage: the 4-point hot bending test, the hot tension test and the hot plane strain compression test. A numerical study is performed in parallel. Based on constitutive data obtained from these three mechanical tests, the mechanical description of a rolling stand is sufficient for satisfactory simulation of the industrial process.

The effect of scaling on interfacial friction in hot rolling of steels

The effect of oxide scale of stainless steels on friction and surface roughness in hot rolling

Oxide scale characterization of ferritic stainless steel and its deformation and friction in hot rolling

Experimental study and numerical simulation of iron oxide scales mechanical behavior in hot rolling

Factors Affecting the Development of Oxide Scales on Austenitic Stainless Steels during Hot Rolling in Steckel Mills

Study on the oxidation of stainless steels 304 and 304L in humid air and the friction during hot rolling

The Role of Oxide-Scale Microtexture on Tribological Behaviour in the Nanoparticle Lubrication of Hot Rolling

Investigation of oxide scale on ferritic stainless steel B445J1M and its tribological effect in hot rolling

Effects of surface preparation on tribological behaviour of a ferritic stainless steel in hot rolling

A Multi-Scale Model for Friction in Cold Rolling of Aluminium Alloy

Effect of Rolling Reduction and Temperature on the Oxide Scale of Hot Rolled Mild Steel Strip

Experimental Study on Adhesion of Oxide Scale on Hot-Rolled Steel Strip

Effect Of Cold Rolling Before Hydrogen Reduction On Reduction Behavior And Morphologies Of Oxide Scale On Hot-Rolled Low-Carbon Steel

Analysis of Rolling Force and Friction in Hot Steel Rolling with Water‐Based Nanolubrication

Numerical Study of the Thermodynamic Behavior and Wear on the Surface of Hot-Rolling Descaling Roll

Multi-Scale Modeling of Microstructure Evolution during Multi-Pass Hot-Rolling and Cooling Process

Oxidation Kinetics and Spallation Model of Oxide Scale during Cooling Process of Low Carbon Microalloyed Steel

A Semi-Empirical Friction Model for Cold Metal Rolling

Numerical Simulation of Oxide Scales Evolution During Hot Strip Rolling

Rolling of Thin Strip and Foil: Application of a Tribological Model for “mixed” Lubrication

Mechanism of Oxidation of Austenitic Stainless Steels under Conditions of Hot Rolling in Steckel Mills