Abstract:With more and more widely used in the industrial field, Active Magnetic Bearings (AMB) have bigger challenge, such as the size and the load capacity are larger than before. In order to increase the reliability of the whole system, a lot of aspects have to be improved to adapt some special industrial requirements. Just like the 10MW high temperature gas-cooled test module reactor (HTR-10GT) with the core made of spherical fuel elements, which was designed and constructed by the Institute of Nuclear and New Energy Technology of Tsinghua University in China, take the AMB as the support bearings. HTR-10GT is the reactor with 3.5 meter long rotor, 230mm diameter, and 15000rpm Rated speed. Since there are some difficulties in HTR-10GT including the blade stages, small gap and so on, the high precision control on magnetic bearing is required very much. Once any part in the system is out of work, the rotor would happen to vibrate, which will lead to turbine blades scraping. The consequences could be disastrous especially when the system is in full power at the rated speed [1]. As you know, the electronic control system is the weakest point in AMB, both in operating site and the control room. Therefore, before engineering applications, the electronic control system must be tested for Electromagnetic Compatibility (EMC). Based on the experimental results, some design would be optimized, to improve anti-interference capability to meet the requirements of HTR-10GT. This paper describes the testing process and gives some solutions for EMC problems during the Electro Magnetic Susceptibility (EMS) test, such as the grounding, cable, wiring, filtering etc. These methods are the fundamental basis for reducing interference and improving the reliability of AMB in the HTR-10GT.

Simulations of TRT Vacuum Vessel Effect on the Magnetic Diagnostics System Sensor Signals

Fluid Simulations of Resistive Drift-Wave Turbulence with Diamagnetic Flow in ZPED Experiments

The Concept of the MSE Diagnostic at the TRT Tokamak Facility

Concept of the Doppler Backscattering Diagnostic on TRT

Reducing systematic errors in time-frequency resolved mode number analysis

Procedure of simulations for Evaluations of Transient Parameters Stability for RF Cavities Due to Effects of Pulsed RF Heating

Options for Implementation of IR Thermography Diagnostics in a Tokamak with Reactor Technologies TRT

Research on New Displacement Sensor Used in Active Magnetic Bearing Systems

THE ELECTRO MAGNETIC COMPATIBILITY TESTS FOR THE AMB SYSTEM ON HTR-10GT

Effects of vacuum magnetic field region on the compact torus trajectory in a tokamak plasma

NONSYNCHRONOUS VIBRATION OF THE ACTIVE MAGNETIC BEARINGS-ROTOR SYSTEM IN THE HIGH TEMPERATURE GAS-COOLED REACTOR

DESIGN AND IMPLEMENTATION OF REDUNDANT SENSORS IN ACTIVE MAGNETIC BEARING

Systematic errors in tokamak magnetic equilibrium reconstruction: a study of EFIT++ at tokamak COMPASS

A high resolution Mirnov array for the Mega Ampere Spherical Tokamak

Magnetic diagnostics for equilibrium reconstructions in the presence of nonaxisymmetric eddy current distributions in tokamaks (invited)

Status of Steady-State Magnetic Diagnostic for ITER and Outlook for Possible Materials of Hall Sensors for DEMO

Plasma Diagnostics in T-15MD Divertor: Tasks, Problems, and Implementation Possibilities

Possibilities of Using Active Neutral Particle Diagnostics at the TRT Facility

Experimental issues of energy balance in open magnetic trap

Circularity Error Analysis of Axial Displacement Sensor Detecting Surface for Active Magnetic Bearings of 10MW High Temperature Gas-Cooled Reactor (HTR-10GT)

Vacuum circuit breaker modelling for the assessment of transient recovery voltages: Application to various network configurations