Abstract:Binder jetting is a sinter-based additive manufacturing technique that integrates the layer-wise deposition in powder bed-based 3D printing with the sintering workflows of metal injection molding (MIM). For each of these powder-based processes, different feedstock characteristics such as spreadability or sinterability is required, and the powder size distribution is typically tuned to achieve the desired characteristics. However, while feedstock sizes have already been commercially standardised for MIM and powder bed fusion processes, a standard size has not been identified for binder jet. In this work, the printability of fine (D50: 14 µm) and coarse (D50: 25 µm) copper powder, representing common MIM and powder bed fusion feedstock sizes, was evaluated on a commercial binder jetting print system. Differences in particle size distribution, flowability, apparent and tapped density of the powders were characterised and correlated to deposited powder bed density, dimensional accuracy, geometrical stability, bulk density and surface topography of the green parts. Furthermore, a novel process-design solution was developed to mitigate layer-shifting print defects observed with the fine powder. The results demonstrate the flexibility of binder jet to produce green parts of varying densities as precursors to high density or high porosity sintered components. Using a layer thickness of 50 µm, a significant green part relative density above 63% was achieved using the fine powder, and a green part porosity above 55% was achieved using the coarse powder. Sintering was conducted at temperatures close to the melting point of copper; however, the formation of carbonaceous by-products prevented densification and necessitates further work before high sintered density can be achieved. Nevertheless, the coarse powder shows promising potential towards the fabrication of porous copper structures with a post-sintered relative density of 51%.

Compaction and sintering characteristics of composite metal powders

Sintering Densification of Cu/Al2O3p Nano-Composite Powders by Electroless Copper Plating

Effects of Sintering Method on Density and Microstructure of Particulate Reinforced Copper Matrix Composites

Numerical study on the warm compaction and solid-state sintering of TiC/316L composite powders from particulate scale

Synthesis process and microstructure of carbon fibres/graphite/copper composites by spark plasma sintering

An Investigation on the Sinterability and the Compaction Behavior of Aluminum/Graphene Nanoplatelets (GNPs) Prepared by Powder Metallurgy

Sintering Behavior of W–30Cu Composite Powder Prepared by Electroless Plating

Process of Sintering Iron-Based Powder Materials Alloyed with Copper with Introduction of Various Plasticizers Into an Initial Charge

Laser shock dynamic compaction of aluminum–copper (Al–Cu) composite metal powder

Mechanical Properties of Sintered Al–Sn–Fe Alloys

The Effect of Sintering Temperature on Graphene Oxide Reinforced Copper Matrix Composite Fabricated Through Powder Metallurgy Technique

Microstructure and Properties of W Cu Composites with Low Copper Content at Different Sintering Temperatures

Process optimization, microstructures and mechanical/thermal properties of Cu/Invar bi-metal matrix composites fabricated by spark plasma sintering

Structure and properties of alumina-reinforced copper matrix composites prepared by powder metallurgy at different sintering temperatures

Sintering process optimization of the additively manufactured pure copper parts through the metal paste deposited process

The effect of sintering time, temperature, and graphene addition on the hardness and microstructure of aluminum composites

Compaction study of in-situ copper alloy reinforced by graphene via powder metallurgy

Effect of sintering temperature on microstructure and tribological properties of copper/graphite composites doped with Ti3AlC2 particles

A printability evaluation of fine and coarse powder in binder jetting of dense and porous copper parts

Fabrication of Ni/Sic Composite Powder by Mechanical Alloying and Its Effects on Properties of Copper Matrix Composites