Abstract:High-strength ceramics were prepared from high alumina fly ash (HAFA) and activated alumina as raw materials with magnesia as a sintering additive. The growth kinetics and influence mechanism of secondary mullite whiskers were investigated. Meanwhile, the effects of the Al2O3/SiO2 mass ratio (A/S) and the amount of magnesia on the content and morphology of mullite in the green body were investigated, so as to emphasize the effect of the liquid phase in the sintering process on the growth of secondary mullite whiskers. The results showed that the aspect ratio of secondary mullite whiskers increased significantly after adding activated alumina to increase the A/S ratio of raw materials. When 30 wt% activated alumina was added, the mullite content increased by 5.39%, and the whisker length increased from 1.36 μm to 4.18 μm. The addition of magnesia improved the liquid phase formed during the sintering process and the K value method was used to determine the sintering liquid phase content under various conditions. It was observed that increasing the magnesia level by 1 wt% could raise the liquid phase content by 5–7%. When the total liquid content of the system was 30–40%, the growth activation energy in the diameter direction of the whisker reduced significantly, promoting the growth of secondary mullite whiskers along the C axis. The morphology of mullite gradually developed from fibrous to long columnar crystal, making it combine more densely with the green body matrix. Furthermore, the staggered long columnar mullite crystal structure changes the fracture mode of ceramics from intergranular to transgranular fracture, which fully uses the high mechanical strength of mullite. As a result, the fracture energy and strength of ceramics are significantly improved.

In situ mullite whisker network formation for high strength and lightweight ceramic proppants

Fabrication of Homogeneous Mullite-Based Fiber Porous Ceramics with High Strength and Porosity

Near‐net‐size Preparation of Porous Mullite Matrix Ceramics with in Situ Formed 3D Mullite Whisker Network

Microstructure and Properties of Porous Anorthite/mullite Whiskers Ceramics with High Porosity

The preparation of mullite foamed ceramics reinforced by in-situ SiC whiskers and their reinforcement mechanism

SPS Fabrication of Whisker and ZrO2 Co-toughened Mullite Ceramics

Fabrication and Properties of Porous Mullite Ceramics from Directly Sintering Ceramic Microspheres

In-situ growth of mullite whiskers and their effect on the microstructure and properties of porous mullite ceramics with an open/closed pore structure

Analysis of Factors Affecting the Preparation of Mullite Whiskers from Silica-Rich Slag and Application Studies

Mullite-corundum gas-permeable refractories reinforced by in-situ formed SiC whiskers

The effect of multiple factors on the synthesis of mullite whiskers based on the S-L-S mechanism and the comparison of strengthening performance

Enhancing properties of oriented short carbon fiber-reinforced refractory castables through direct ink writing and in-situ synthesis of whiskers

Preparation and Mechanical Properties of SiC Whisker and Nanosized Mullite Particulate Reinforced TZP Composites

An engineering ceramic-used high-temperature-resistant inorganic phosphate-based adhesive self-reinforced by in-situ growth of mullite whiskers

Preparation of mullite whiskers from high alumina fly ash and its reinforced porous structure

Fabrication and characterization of porous mullite ceramics with ultra-low shrinkage and high porosity via sol-gel and solid state reaction methods

Properties and mechanism of mullite whisker toughened ceramics

Seed assisted in-situ synthesis of porous anorthite/mullite whisker ceramics by foam-freeze casting

Properties and Structure of Micro Porous Mullite-Corundum Refractory with High Strength

A novel sintering additive system for porous mullite-bonded SiC ceramics: High mechanical performance with controllable pore structure

Preparation And High-Temperature Strengthening Of Tetragonal Zirconia Mullite Whisker Composites