Abstract:High-strength ceramics were prepared from high alumina fly ash (HAFA) and activated alumina as raw materials with magnesia as a sintering additive. The growth kinetics and influence mechanism of secondary mullite whiskers were investigated. Meanwhile, the effects of the Al2O3/SiO2 mass ratio (A/S) and the amount of magnesia on the content and morphology of mullite in the green body were investigated, so as to emphasize the effect of the liquid phase in the sintering process on the growth of secondary mullite whiskers. The results showed that the aspect ratio of secondary mullite whiskers increased significantly after adding activated alumina to increase the A/S ratio of raw materials. When 30 wt% activated alumina was added, the mullite content increased by 5.39%, and the whisker length increased from 1.36 μm to 4.18 μm. The addition of magnesia improved the liquid phase formed during the sintering process and the K value method was used to determine the sintering liquid phase content under various conditions. It was observed that increasing the magnesia level by 1 wt% could raise the liquid phase content by 5–7%. When the total liquid content of the system was 30–40%, the growth activation energy in the diameter direction of the whisker reduced significantly, promoting the growth of secondary mullite whiskers along the C axis. The morphology of mullite gradually developed from fibrous to long columnar crystal, making it combine more densely with the green body matrix. Furthermore, the staggered long columnar mullite crystal structure changes the fracture mode of ceramics from intergranular to transgranular fracture, which fully uses the high mechanical strength of mullite. As a result, the fracture energy and strength of ceramics are significantly improved.

Properties and mechanism of mullite whisker toughened ceramics

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Analysis of Factors Affecting the Preparation of Mullite Whiskers from Silica-Rich Slag and Application Studies

Preparation of Fly Ash-Based Porous Ceramic with Alumina as the Pore-Forming Agent

The effect of multiple factors on the synthesis of mullite whiskers based on the S-L-S mechanism and the comparison of strengthening performance

The preparation of mullite foamed ceramics reinforced by in-situ SiC whiskers and their reinforcement mechanism

In-situ growth of mullite whiskers and their effect on the microstructure and properties of porous mullite ceramics with an open/closed pore structure

Effect of the in-situ SiC whiskers on the alkali attack resistance mechanism of mullite-SiC foam ceramics

Preparation of mullite whiskers from high alumina fly ash and its reinforced porous structure

SPS Fabrication of Whisker and ZrO2 Co-toughened Mullite Ceramics

Microstructure and Properties of Porous Anorthite/mullite Whiskers Ceramics with High Porosity

Mechanical properties of reinforced porcelain slabs with mullite whiskers introduced by aluminum silicate fiber

Significantly improved mechanical properties of mullite ceramics by adding AlOOH with different sizes and morphologies

Low sintering shrinkage and high strength of porous mullite–zirconia ceramics: Effect of AlF3 and ZrSi2 contents

Effect of AlF3 Content on the Properties of In-situ Generated Mullite Whisker Reinforced High Aluminum Castables

Preparation and Mechanical Properties of SiC Whisker and Nanosized Mullite Particulate Reinforced TZP Composites

Formation mechanism of whiskers in Al–MgAl2O4–MgO refractories at 1400 °C under N2 atmosphere

Mullite Whisker Reinforced Porous Anorthite Ceramics with Low Thermal Conductivity and High Strength

A new mullite foamed ceramic prepared by direct-foaming methods in parallel with a mechanical activation technique

Preparation and mechanical properties of SiC whisker-reinforced alumina

Preparation and properties of porous mullite-based ceramics fabricated by solid state reaction