Preparation of near net size porous alumina‐calcium aluminate ceramics by gelcasting‐pore‐forming agent processs
Bian‐Lei Hao,Ying Lang,Da‐Qian Bian,Chang‐An Wang
DOI: https://doi.org/10.1111/jace.17075
IF: 4.186
2020-03-07
Journal of the American Ceramic Society
Abstract:<p>In the processing of porous ceramics, shrinkage from green body to sintered compact during drying and sintering is one of key concerns which affect microstructure and properties of the porous ceramics. Through releasing gases from the burning of the pore forming agents and volume expansion from formation of low density resultants during sintering, the sintering shrinkage can be effectively compensated and near net size preparation can be achieved. Herein, near net size porous alumina‐calcium aluminate ceramics with controllable shrinkage have been prepared by a combination of gelcasting and pore‐forming agent process through adjusting the amount of CaCO<sub>3</sub> and polymethyl methacrylate (PMMA) microspheres added. Al<sub>2</sub>O<sub>3</sub> and CaCO<sub>3</sub> were used as raw material, polymethyl methacrylate (PMMA) microspheres were used as pore‐forming agent, isobutylene/maleic anhydride copolymer (Isobam104) was used as gelling agent and dispersing agent. The effects of the addition amounts of CaCO<sub>3</sub> and PMMA in the slurry on the phase composition, shrinkage, porosity, and strength of porous alumina‐calcium aluminate ceramics were investigated. The results show that as the CaCO<sub>3</sub> addition amount increases from 0 wt% to 20 wt%, the shrinkage of the samples gradually decreases from 7.3 % to ‐1.4 %, and the consequent porosity increases from 58 % to 66 %, while the compressive strength increases from 5.9 MPa to 15.5 MPa. When PMMA content increases from 10 wt% to 50 wt%, the shrinkage of the samples decreases first and then increases, the porosity increases from 51 % to 74 %, and the compressive strength decreases from 12.5 MPa to 5.3 MPa. The mechanisms for controlling of shrinkages during preparation of porous alumina‐calcium aluminate ceramics can be attributed to the following aspects: on one hand, gases release from burning of PMMA and decomposition of CaCO<sub>3</sub> during sintering; on the other hand, volume expansion due to formation lower density calcium aluminates which come from the reactions between CaO and Al<sub>2</sub>O<sub>3</sub>. Near net size preparation technique is of great significance for the manufacture of porous ceramics since the subsequent machining cost can be effectively reduced.</p>
materials science, ceramics