Abstract:Numerous full-scale in situ tests have been conducted to assess the effect of thermal cycles on the pile response. However, those studies investigated the response of only precast and cast in-situ energy piles, with limited focus on the impact of the applied mechanical load on the pile response. This study presents the results of a field test conducted on a new type of energy pile, i.e. a displacement cast in-situ energy pile in multilayered soft soils, subjected to different fixed mechanical loads while undergoing simultaneous thermal cycles. Four tests were carried out, each corresponding to various axial loads ranging from 0 to 60% of the pile's estimated bearing capacity. After applying the axial load on the pile head (0%, 30%, 40%, or 60% of the bearing capacity), the pile was subjected to up to ten thermal cycles. The highest magnitudes of thermal axial strains were observed near the pile top due to the lowest restraint provided by the made ground layer in all tests. Under zero (0%) mechanical load, the thermal axial strains near the pile head were elastic and recoverable, while residual strain was observed near the toe. Under reasonable working mechanical loads (30%, 40%, or 60%) residual strains were observed near both the pile head and the toe, with higher residual strains observed under higher mechanical loads. The results indicate that the cyclic thermal loadings could induce an increase in the compressive stress in the energy pile, attributed to the drag-down effects of the surrounding soil. The compressive stress induced by drag-down effects counteracts thermally induced tensile stress and thus leads to an insignificant effect on the energy pile during cooling. A limited impact of the shaft capacity was observed and was mainly attributed to the drag-down of the surrounding soil and thermal creep along the pile-soil interface.

Influence of temperature on soil–pile interface shear strength

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Investigating Temperature Effects on the Shear Behavior of Clays: Molecular Dynamics Simulations

Influence of Thermal Loading on Bearing Capacity of Geothermal Energy Piles

Bearing Performance of Geothermal Energy Pile Subjected to Thermal Loading

Thermo-mechanical behavior of energy piles in high plasticity clays

Model Test on Bearing Characteristic of Static Drill Rooted Energy Pile

Temperature effects on pile–soil interface behaviour in the case of piles in sand

Thermally induced mechanical interactions of energy pile groups subjected to cyclic nonsymmetrical thermal loading

Effect of stress history of saturated clay on engineering behaviour of an energy pile

Interface shear strength characteristics of steel piles in frozen clay under varying exposure temperature

Shear creep behaviour of soil-structure interfaces under thermal cyclic loading

Effects of Temperature and Thermal Cycles on the Elastic Shear Modulus of Saturated Clay

Field tests on thermal response characteristics of micro-steel-pipe pile under multiple temperature cycles

Effects of Thermal Cycles on Soil Behaviour: Theoretical and Experimental Studies

Bearing characteristic of static drill rooted pile considering condition of energy carrier

Thermo-mechanical radial expansion of heat exchanger piles and possible effects on contact pressures at pile–soil interface

Experimental research on reinforcement-soil interface stiffness and damping ratio under cyclic shearing

An In-Situ Experimental Investigate of Thermo-Mechanical Behavior of a Large Diameter over Length Energy Pile

Thermal Performance of Energy Piles in Unsaturated Soils: Experiment, Simulation, and Case Study

Full-scale in-situ tests on a displacement cast in situ energy pile: Effects of cyclic thermal loads under different mechanical load levels on pile stress and strain