Abstract:Finger seal is a type of compliant seal configuration that has superior sealing performance compared with conventional labyrinth seals and brush seals. However, complex working conditions lead to leakage, thermal gradient and deformation, which can be more serious for a contacting finger seal due to frictional heating. In this paper, a leakage and thermal performance analysis method coupled with porous media and a real structure model was developed to numerically simulate the leakage, heat transfer and thermal deformation characteristics of a contacting finger seal. The method innovatively established a porous media fluid dynamics and heat transfer model and modified the frictional heating model by introducing the concept of a friction work conversion ratio. Then, the thermal deformation of the fingers was calculated on the basis of pressure and temperature results by using the thermal-stress module of ANSYS Workbench. The results show that the leakage analysis porous media model has good calculation accuracy and most of the fluid leaks through the finger foot, while the pressure drops mainly in this field. The highest finger temperature occurs at the downstream side of the contact surface between the finger foot and the rotor. The largest thermal deformation of each laminate occurs at the finger foot toe and increases slightly along the flow direction. Additionally, the largest relative circumferential thermal deformation can reduce the gap between the fingers by approximately 5%, which is beneficial for reducing leakage. It is suggested to increase the seal inner diameter at the finger foot toe but decrease it at the finger foot heel during the design process to decrease wear and leakage.

Fretting behavior of static metal seal and testing apparatus for fretting friction with low/high temperature

Experimental study on the performance of cryogenic seal structure with indium

High-Temperature And High-Speed Abadable Tester For Abradability Test Of Seal Coatings

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Tribological Properties of Seals in Integrated Transmission of Vehicle

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

A Friction Evaluation Method Based on Barrel Compression Test

High-speed Abrasion Experimental Research of an Abradable Seal Rubber

Development of the High-speed Sliding-rolling Contact Friction Testing Machine

Simulation and experimentation on the contact width and pressure distribution of lip seals

Study on fretting behavior of rubber O-ring seal in high-pressure gaseous hydrogen

Analysis and Experimental Study on Friction and Wear Characteristics of Super High-Speed Mechanical Seal

On Frictional Performance of Sintering Materials Used by Mechanical Seals in Water

Experiment and Simulation on the Ferrofluid Boundary Deformation and Fluctuation Characters of a High-Speed Rotary Seal

Sealing failure and fretting fatigue behavior of fittings induced by pipeline vibration

Study on the thermal-stress coupling simulation and surface friction of mechanical seal for water pump

Study on Characteristics of Stress Relaxation for Typical Metallic Sealing Materials

Experimental investigation on frictional behavior and sealing performance of different composites for seal application

Leakage, heat transfer and thermal deformation analysis method for contacting finger seals based on coupled porous media and real structure models

A fretting test apparatus for measuring friction hysteresis of bolted joints

Study on the Friction Behavior and Abnormal Conditions of Non-contact Mechanical Seal Based on Acoustic Emission