Abstract:Numerical methods are crucial to supporting the development of new technology in different industries, especially steelmaking, where many phenomena cannot be directly measured or observed under industrial conditions. As a result, further designing and optimizing steelmaking equipment and technology are not easy tasks. At the same time, numerical approaches enable modeling of various phenomena controlling material behavior and, thus, understanding the physics behind the processes occurring in different metallurgical devices. With this, it is possible to design and develop new technological solutions that improve the quality of steel products and minimize the negative impact on the environment. However, the usage of numerical approaches without proper validation can lead to misleading results and conclusions. Therefore, in this paper, the authors focus on the development of the CFD-based (computational fluid dynamics) approach to investigate the liquid steel flow inside one metallurgical device, namely a ladle furnace combined with an EMS (electromagnetic stirring) system. First, a numerical simulation of electromagnetic stirring in a scaled mercury model of a ladle furnace was carried out. The numerical results, such as stirring speed and turbulent kinetic energy, were compared with measurements in the mercury model. It was found that the results of the transient multiphase CFD model achieve good agreement with the measurements, but a free surface should be included in the CFD model to simulate the instability of the flow pattern in the mercury model. Based on the developed model, a full-scale industrial ladle furnace with electromagnetic stirring was also simulated and presented. This research confirms that such a coupled model can be used to design new types of EMS devices that improve molten steel flow in metallurgical equipment.

3D CFD Model of Ladle Heat Transfer With Gas Injection

Numerical Simulation of Heat Transfer Phenomenon in Steel Making Ladle

Multiphysics Numerical Simulation Model and Hydraulic Model Experiments in the Argon-Stirred Ladle

Numerical Investigations on the Slag Eye in Steel Ladles

Numerical simulation for heat transfer behavior of copper slag ladle under air-cooling mechanism

Numerical Simulation of Multiphase Flow Behavior in Hot Metal Ladle Desulfurization with Bottom Powder Injection and Electric Field

Numerical Simulation of Transient Flow and Heat Transfer in a Steel Ladle During Holding Period

Numerical Investigation on Role of Bottom Gas Stirring in Controlling Thermal Stratification in Steel Ladles

Numerical Analysis of Slag–Steel–Air Four-Phase Flow in Steel Continuous Casting Model Using CFD-DBM-VOF Model

Computational Fluid Dynamics Simulation of Gas–Matte–Slag Three-Phase Flow in an ISASMELT Furnace

Numerical Simulation of Fluid Flow and Heat Transfer in a Ductile Iron Ladle During Holding and Teeming

Re-visiting the single-phase flow model for liquid steel ladle stirred by gas

Analysis of Temperature Losses of the Liquid Steel in a Ladle Furnace During Desulfurization Stage

Development and Validation of Computational Fluid Dynamics Model of Ladle Furnace with Electromagnetic Stirring System

Modeling of Motion of Inclusions in Argon‐Stirred Steel Ladles

Numerical analysis for the heat transfer behavior of steel ladle as the thermoelectric waste-heat source

Simulation Analysis of Influence of Argon Gas Injection Hole Position on Flow Field in Steel Ladle

Numerical Simulation of Fluid Flow and Solidification in Continuous Slab Casting Mould Based on Inverse Heat Transfer Calculation

3D Numerical Simulation of Temperature Field Coupled with Flow Field of the Liquid Metal in Shot Sleeve of Die Casting Process

Numerical Simulation of Molten Slag Deposition in Radiant Syngas Cooler with a CFD-Based Model