Abstract:This article presents a review of the research into gas stirring in ladle metallurgy carried out over the past few decades. Herein, the physical modeling experiments are divided into four major areas: (1) mixing and homogenization in the ladle; (2) gas bubble formation, transformation, and interactions in the plume zone; (3) inclusion behavior at the steel–slag interface and in the molten steel; and (4) open eye formation. Several industrial trials have also been carried out to optimize gas stirring and open eye formation. Approaches for selecting criteria for scaling to guarantee flow similarity between industrial trials and physical modeling experiments are discussed. To describe the bubble behavior and two-phase plume structure, four main mathematical models have been used in different research fields: (1) the quasi-single-phase model, (2) the volume of fluid (VOF) model, (3) the Eulerian multiphase (E–E) model, and (4) the Eulerian–Lagrangian (E–L) model. In recent years, the E–E model has been used to predict gas stirring conditions in the ladle, and specific models in commercial packages, as well as research codes, have been developed gradually to describe the complex physical and chemical phenomena. Furthermore, the coupling of turbulence models with multiphase models is also discussed. For physical modeling, some general empirical rules have not been analyzed sufficiently. Based on a comparison with the available experimental results, it is found that the mathematical models focusing on the mass transfer phenomenon and inclusion behaviors at the steel-slag interface, vacuum degassing at the gas–liquid interface, dissolution rate of the solid alloy at the liquid–solid interface, and the combination of fluid dynamics and thermodynamics need to be improved further. To describe industrial conditions using mathematical methods and improve numerical modeling, the results of physical modeling experiments and industrial trials must offer satisfactory validations for the improvement of numerical modeling.

Modeling of Motion of Inclusions in Argon‐Stirred Steel Ladles

Fluid flow, slag entrainment, and composition evolution of slag inclusions during vacuum degassing refining

Re-visiting the single-phase flow model for liquid steel ladle stirred by gas

Multiphysics Numerical Simulation Model and Hydraulic Model Experiments in the Argon-Stirred Ladle

Collision-coalescence among inclusions with bubble attachment and transport in molten steel of RH

Simulation Analysis of Influence of Argon Gas Injection Hole Position on Flow Field in Steel Ladle

Physical Simulation Study on Flow Field Characteristics of Molten Steel in 70t Ladle Bottom Argon Blowing Process

Prediction on the three-dimensional spatial distribution of the number density of inclusions on the entire cross section of a steel continuous casting slab

Inclusion Transfer Phenomenon under Unsteady Multiphase Flow during Rheinstahl–Heraeus Vacuum Treatment Process

Numerical Investigation on Coalescence Behavior of Liquid Inclusion Particles in Argon Bubble Wake Flow

3D CFD Model of Ladle Heat Transfer With Gas Injection

Numerical Simulation of Convection and Inclusion Distribution During Solidification in a Heavy Steel Ingot

Modeling of Ladle Refining Process Considering Mixing and Chemical Reaction

Numerical Investigation on Transient Flow and Inclusion Removal Behavior in Tundish During Ladle Change Process

Two-Way PBM–Euler Model for Gas and Liquid Flow in the Ladle

Model Investigation of Argon Injection into Liquid Steel at Ladle Furnace Station with Using of Innovative Module

Numerical Simulation of Multiphase Flow in Steel Continuous Casting Mold Using a Novel Euler–Euler–Lagrange Method

Research Status of Numerical Simulation of Nonmetallic Inclusions Interfacial Removal

Multiphase Model for the Prediction of Shrinkage Cavity, Inclusion and Macrosegregation in a 36-Ton Steel Ingot

Numerical Simulation on the Motion Behavior of Micro-inclusions at the Steel–Slag Interface

A Review of Physical and Numerical Approaches for the Study of Gas Stirring in Ladle Metallurgy