Abstract:The refractory–slag–metal–inclusion multiphase reaction model was developed by integrating the refractory–slag, slag–metal, and metal–inclusion elementary reactions in order to predict the evolution of inclusions during the secondary refining processes. The mass transfer coefficient in the metal and slag phase, and the mass transfer coefficient of MgO in the slag were employed in the present multiphase reactions modeling. The “Effective Equilibrium Reaction Zone (EERZ) Model” was basically employed. In this model, the reaction zone volume per unit step for metal and slag phase, which is dependent on the ‘effective reaction zone depth’ in each phase, should be defined. Thus, we evaluated the effective reaction zone depth from the mass transfer coefficient in metal and slag phase at 1873 K (1600 °C) for the desulfurization reaction which was measured in the present study. Because the dissolution rate of MgO from the refractory to slag phase is one of the key factors affecting the slag composition, the mass transfer coefficient of MgO in the ladle slag was also experimentally determined. The calculated results for the variation of the composition of slag and molten steel as a function of reaction time were in good agreement with the experimental results. The MgAl2O4 spinel inclusion was observed at the early to middle stage of the reaction, whereas the liquid oxide inclusion was mainly observed at the final stage of the refining reaction. The content of CaO sharply increased, and the SiO2 content increased mildly with the increasing reaction time, while the content of Al2O3 in the inclusion drastically decreased. Even though there is slight difference between the calculated and measured results, the refractory–slag–metal multiphase reaction model constructed in the present study exhibited a good predictability of the inclusion evolution during ladle refining process.

Modeling of Ladle Refining Process Considering Mixing and Chemical Reaction

Modeling of the secondary refining process of steel

Simulation of Ladle Refining Reactions in Si–Mn‐Killed Steel

Multiphysics Numerical Simulation Model and Hydraulic Model Experiments in the Argon-Stirred Ladle

Refractory–Slag–Metal–Inclusion Multiphase Reactions Modeling Using Computational Thermodynamics: Kinetic Model for Prediction of Inclusion Evolution in Molten Steel

Modeling Framework for the Simulation of an Electric Smelting Furnace Considering Freeze Lining Formation

Computational study of non-isothermal slag eye formation and its effects on ladle refining

Re-visiting the single-phase flow model for liquid steel ladle stirred by gas

Numerical Understanding on Refractory Flow-Induced Erosion and Reaction-Induced Corrosion Patterns in Ladle Refining Process

Physical modeling of two-phase liquid–gas processes occurring in the refining ladle for Fe–Si alloy refining process

Flow, Heat‐Transfer, and Mixing Behaviors of Scrap Steel in a Refining Ladle with Bottom Blowing

Dynamic mass variation and multiphase interaction among steel, slag, lining refractory and nonmetallic inclusions: Laboratory experiments and mathematical prediction

A thermodynamic model of the titanium distribution behaviour between slag and molten steel during LF refining process: description and application

Mathematical model for design of optimized multi-component slag for electroslag remelting

A coupled mathematical model and experimental validation of oxygen transport behavior in the electro-slag refining process

Modeling of Motion of Inclusions in Argon‐Stirred Steel Ladles

Mathematical Model of Multistage and Multiphase Chemical Reactions in Flash Furnace

Analysis of Temperature Losses of the Liquid Steel in a Ladle Furnace During Desulfurization Stage

Pragmatical physics-based model for ladle lifetime prediction

Development and Validation of Computational Fluid Dynamics Model of Ladle Furnace with Electromagnetic Stirring System

Numerical simulation on the multiphase flow and reoxidation of the molten steel in a two-strand tundish during ladle change