Abstract:The extensive application of multi‐layer ceramic capacitors (MLCC) provides an attractive development for terminal electrode pastes. However, the growing requirement for advanced glass materials used in terminal electrode pastes is substantiated. Therefore, to advance the development of electrode pastes, better development and deeper exploration of glass powder are required. Here, a series of BaO‐ZnO‐B2O3‐SiO2 (BZBS) glasses were prepared by melt‐quenching technique, which are used to investigate the effect of the introduction of BaO on structure and properties of the ZnO‐B2O3‐SiO2 (ZBS) glass. With the introduction of BaO, the relative amount of [BO4] was much less, which made the glass network structure loosen, decreased the glass transition temperature (Tg) and increased the coefficient of thermal expansion (CTE) of the glass. The decreasing contact angle was observed on the surface of barium titanate (BaTiO3) substrate. When the BaO content was around 3–7 mol%, the stability of ZBS glass frit could be strengthened by inhibiting the precipitation of Zn2SiO4 crystal. In addition, to further characterize the effect of glass on terminal electrode paste, BZBS glass powder was adopted to prepare copper electrode paste, which was printed on BaTiO3 substrate and subsequently fired at 800 ° C for 10 min. With the related copper paste containing ZBS glass doped with 7 mol% BaO, the optimum value of acid resistance and sheet resistance (1.99 mΩ) were exhibited, at which the coated copper paste formed a dense conducting layer.This article is protected by copyright. All rights reserved

Transparent low-melting point glass powder for dielectric paste and preparation method thereof

Low-melting-point glass powder and preparation method thereof

Fluorescent Powder/glass Complex Applied to Semiconductor Lighting and Preparation Method Thereof

Glass sealing material for photovoltaic device, paste and preparation method thereof

Percolative Ceramic Composites with Giant Dielectric Constants and Low Dielectric Losses

Low Melting Pbo-Zno-P2o5 Glasses

Synthesis and microwave dielectric properties of (Ca0.7Mg0.3)SiO3 nanopowder prepared at low temperature

Study on Low-Temperature Conductive Silver Pastes Containing Bi-Based Glass for MgTiO3 Electronic Power Devices

Low-loss Insulating-Conductive Ceramic Composite with Giant Permittivity and High Permeability Using Glass Phase As Separating Layer

Tuning size distribution of zinc borosilicate glass additives by the length of gallate molecular chain during ball milling for lowering the sintering temperature of copper paste

Synthesis of PVZ Glass and Its Improvement on Mechanical and Electrical Properties of Low Temperature Sintered Silver Paste

The Structures and Dielectric Properties of Ba0.80Sr0.20TiO3/Pb0.82La0.18TiO3 Composite Thick Films with Addition of PbO–B2O3 Glass

Effect of properties and crystallization behavior of BaO‐ZnO‐B 2 O 3 ‐SiO 2 glass on the electrical conductivity of Cu paste

Optimizing the size distribution of zinc borosilicate glass powder by organic solvent and tetradecylphosphonic based wet milling

Regulating the valence state of lead ions in lead aluminosilicate glass to improve the passivation performance for advanced chip packaging

Three‐phase borate solid solution with low sintering temperature, high‐quality factor, and low dielectric constant

Method for preparing high-conductivity zinc oxide ceramic at ultralow temperature

Preparation of B2O3-P2O5-SiO2 glass-ceramics by the sol-gel method

Low Dielectric Constant Borophosphosilicate Glass-Ceramics Doped with Pbf2

A simple and an effective method for the fabrication of densified glass-ceramics of low temperature co-fired ceramics

Low-Temperature Combustion Synthesis of Cordierite Powder and Its Characteristic