Abstract:Abstract Low‐noise and low‐voltage operation is prime requirement of an operational transconductance amplifier for low frequency applications. However, achieving low‐noise operation at low supply voltages is a challenging task in CMOS technology owing to noise‐power and noise‐stability tradeoffs. This article outlines, the design of four differential bias self‐cascode (DBSC) operational transconductance amplifiers (OTAs) working at ±0.7 V. The four design techniques namely gate driven (GD), bulk driven (BD), bulk driven quasi‐floating gate (BDQFG), and gate driven quasi floating bulk (GDQFB) have been applied on DBSC OTAs. The designing aspects and performance parameters of these four OTAs such as gain, gain‐bandwidth, input referred noise ( IRN ), settling time (ST), common mode rejection ratio (CMRR), total harmonic distortion, input impedance, transconductance, power consumption, area consumption and process/mismatch variations have been fairly compared in this work. These DBSC OTAs have been designed and simulated using a standard 0.18‐μm 6M1P CMOS N‐well process. The results infer GD DBSC OTA shows high CMRR of 125.83 dB. While the BD DBSC OTA consumes very low power of 0.2 μW. The BDQFG DBSC OTA shows low 1% ST of 24.83 μS. The GDQFB DBSC OTA show high transconductance (2.35 mS), high gain (64.97 dB), and low IRN (0.40 μV/√Hz at 10 Hz). The theoretical predictions for these OTAs agree with the post‐layout simulations. The proposed OTAs can be used for designing various analog circuits such as programmable gain amplifiers, variable gain amplifiers, and transimpedance amplifiers for low‐frequency biomedical and health care applications.

0.5-V analog circuit techniques and their application in OTA and filter design

High gain, high speed OTA for S/H circuit in 14-b 100-MS/s Pipeline ADC

The Design of a Low-Voltage Rail-to-Rail CMOS Operational Amplifier

0.5 V Multiple-Input Fully Differential Operational Transconductance Amplifier and Its Application to a Fifth-Order Chebyshev Low-Pass Filter for Bio-Signal Processing

A High-Performance,Low-Power ΣΔ Modulator for Digital Audio Applications

A 1-Mw K-band Gate AC-coupled VCO with 0.25 V Supply Voltage

On the Design of an Ultra-Low-Power Ultra-Low-Voltage Inverter-Based OTA

0.5-V High Linear Fully Differential Multiple-Input Bulk-Driven OTA With Effective Self-Embedded CMFB

An Ultra-low-power Gain-boost Class-C Inverter and Its Application

Design of High Performance Operational Transconductance Amplifier

A High-pass Filter with On-chip Body Bias Technique for Neural Signals Processing

A 0.5-V 0.02% THD Bulk-Driven OTA for Continuous-Time Applications in 180 nm CMOS

A Linear CMOS OTA and Its Application to a 3. 3V 20MHz High-Q g m-C Bandpass Filter

Design of a Low-Power/Low-Voltage Class-AB OTA

Design of low‐voltage low‐noise operational transconductance amplifiers for low frequency applications

Low-Voltage Mixed-Mode Analog Filter Using Multiple-Input Multiple-Output Operational Transconductance Amplifiers

A Wide Linear Range Ultra-low Transconductance Amplifier for Biomedical Sensor Applications

Design of A Low Power Low Voltage CMOS Opamp

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

Low Power Low Voltage Bulk Driven Balanced OTA

An Ultra-Low-Voltage Transconductance Stable and Enhanced OTA for ECG Signal Processing