Abstract:As an important joint material, tantalum (Ta) needs to be studied intensively in terms of wear and corrosion resistance. Two films of Ta/Ti/DLC (diamond-like carbon) (referred to as TD film) and Ta/Ti/TiN/Ti/DLC (referred to as TTTD film) were prepared by magnetron sputtering technology, and their electrochemical corrosion performance in lactic acid and sodium bicarbonate solutions was also investigated. The morphology observation, electrochemical corrosion experiment, and static contact angle measurement were carried out using a scanning electron microscope, electrochemical workstation, and a contact angle meter. This paper mainly discusses and analyzes the corrosion influencing factors and corrosion mechanisms of these two films under two different environments. The 20-day immersion experiments show that the TD film in both solutions results in severe surface corrosion due to its loose structure and many internal defects. In contrast, the surface of the TTTD film with a dense structure, a multilayer structure, and a thicker thickness is not corroded under the same conditions. The electrochemical corrosion experiments show that the corrosion resistance of the TD film is worse than that of the Ta substrate, while the TTTD film has the strongest corrosion resistance, improving the corrosion resistance of the Ta substrate. Although the TD film had a higher sp3 content than the TTTD film, it does not provide protection to the Ta substrate due to increased structural defects in the TD film. The results of the contact angle show that the contact angle of the TTTD film is smaller than that of the TD film in both solutions. However, the TTTD film has the lowest roughness and the densest structure, and thus the TTTD film is more resistant to corrosion. It is finally concluded that the surface morphology and internal structure of the films are the main factors affecting corrosion resistance. This provides an important reference for the application of DLC film in weak alkaline and weak acid environments.

Structure related corrosion behavior of DLC films in high Cl − environment

Probing the Friction and Wear Behaviors of Diamond-Like Carbon Film in HCl and H2SO4 Media

Tribological and Corrosive Behavior under HCl Corrosive Environment of Diamond-Like Carbon Films with Doped H, Cr and WC

Tribo-mechanism of Amorphous Carbon Films under Corrosion Solution and Various Mechanical Loads

Corrosion behavior and passive stability of multilayer DLC-Si coatings

A Novel Diamond-Like Carbon Film

Enhanced tribological and corrosion properties of DLC/CrN multilayer films deposited by HPPMS

Nanomechanical and Electrochemical Properties of Diamond-Like Carbon (DLC) Films Deposited by Plasma Enhanced Chemical Vapor Deposition (PECVD) Technique

Corrosion Properties of DLC Film in Weak Acid and Alkali Solutions

Wear-resistance of Diamond-like Carbon Thin Films Deposited on the Metal Seal Ring Surface by Plasma Gun at an Atmospheric Pressure

Corrosion and Scratch Resistance of DLC Coatings Applied on Chromium Molybdenum Steel

Role of TiC nanocrystalline and interface of TiC and amorphous carbon on corrosion mechanism of titanium doped diamond-like carbon films: Exploration by experimental and first principle calculation

Advances in DLC coatings by hybrid PSII and PECVD as a barrier to corrosion in simulated body fluid*

Characterisation of Ultra-Thin DLC Coatings by SEM/EDX, AFM and Electrochemical Techniques

Failure Behavior of Hydrogenated and Hydrogen Free Diamond Like Carbon (DLC) Films in Water Environment

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Study on composition, microstructure and hardness of DLC films by vcad

Corrosion Protection of Ultra-Thin Diamond-Like Carbon Films on Cuprum

Structure and Anticorrosion, Friction, and Wear Characteristics of Pure Diamond-Like Carbon (DLC), Cr-DLC, and Cr-H-DLC Films on AZ91D Mg Alloy

Effects on Tribological Properties and Corrosion Resistance of Zr-doped DLC Films

Improvement in Anti-Corrosion Property of Hydrogenated Diamond-Like Carbon Film by Modifying Crc Interlayer