Abstract:Concerns about arsenic emission issues are growing as the arsenic discharged from coal-fired power plants seriously endangers the ecological environment and public health. The gas-phase arsenic capture by a CaO–Ca12Al14O33 synthetic sorbent at 1000–1200 °C in the simulated flue gas was conducted, with the influence of the addition ratio of Ca12Al14O33, temperature, retention time, and acid gases NO/SO2 considered in the study. The results indicated that the synthetic sorbent containing 15 wt % Ca12Al14O33 (Ca85Al15) exhibited much better arsenic adsorption performance than CaO, which was ascribed to the greatly strengthened sintering resistance of CaO particles by adding Ca12Al14O33, enabling arsenic adsorption and chemical reactions. Both the increasing temperature and retention time facilitated arsenic adsorption by Ca85Al15, and the hypertoxic arsenic vapor (As3+) was converted into arsenate (Ca3(AsO4)2) with less toxicity. In the presence of NO, the arsenic capture was gradually suppressed with increasing retention time. On the other hand, SO2 could slightly facilitate the capture of arsenic at 1000–1100 °C for 10 min; nevertheless, due to the formation of Ca4Al6O12SO4, the promotion effect was inhibited at a higher temperature and a longer retention time. In general, the study provided a basis for developing highly efficient solid sorbents toward controlling arsenic vapor emission derived from coal combustion, and the appropriate conditions for arsenic capture were at 1000–1100 °C.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03686?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03686</a>.Schematic illustration of the preparation procedure to synthesize CaO–Ca12Al14O33 (Figure S1) and diagrams of the adsorption–desorption isotherms of Ca85Al15 and pore-size distribution curves of CaO and synthetic sorbents with different CaO/Ca12Al14O33 ratios based on BJH adsorption data (Figure S2) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03686/suppl_file/ef0c03686_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Capture of arsenic in coal combustion flue gas at high temperature in the presence of CaSiO3 with good anti-sintering

Stable and Efficient As2O3 Removal from Simulated Flue Gas Using Al2O3/CaSiO3 Prepared by Anhydrous Grinding and Calcination Method

Insight into High Temperature Gas-Phase Arsenic Capture by a CaO–Ca 12 Al 14 O 33 Synthetic Sorbent

Simultaneous Removal of So2 and Trace As2o3 from Flue Gas: Mechanism, Kinetics Study, and Effect of Main Gases on Arsenic Capture

Chemically bonded zirconium oxide into CaO-based high-temperature coal-fired flue gas As 2 O 3 absorbents for enhanced anti-sintering properties: Experimental and DFT study

Deep insight into the effect of NaCl/HCl/SO2/CO2 in simulated flue gas on gas-phase arsenic adsorption over mineral oxide sorbents

Microscopic Spherical α-Fe 2 O 3 for Highly Efficient Gaseous Arsenic Capture in Simulated Flue Gas Under a Wide Temperature Range

Improved removal of selenium by calcite-derived CaO with porosity and anti-sintering in presence of acid gas

Microscopic Spherical Α-Fe2o3 for Highly Efficient Gaseous Arsenic Capture in Simulated Flue Gas under a Wide Temperature Range

Unraveling the capture mechanism of gaseous As2O3 over H-ZSM-5 zeolite from coal-fired flue gas: Experimental and theoretical insights

Gaseous Arsenic Capture in Flue Gas by CuCl 2 -Modified Halloysite Nanotube Composites with High-Temperature NO x and SO x Resistance

Research on Vapor Mercury Adsorption by Ca-Based Sorbents

Adsorption mechanism of As2O3 by Ca-Si-Al mineral: An experimental and DFT study

Role of CO 2 on trace arsenic and selenium separation from coal-fired flue gas by CaO

In-Furnace Control of Arsenic Vapor Emissions Using Fe 2 O 3 Microspheres with Good Sintering Resistance

Re-using of coal-fired fly ash for arsenic vapors in-situ retention before SCR catalyst: Experiments and mechanisms

As2O3 capture from incineration flue gas by Fe2O3-modified porous carbon: Experimental and DFT insights

Capture gaseous arsenic in flue gas by amorphous iron manganese oxides with high SO2 resistance

Simultaneous Removal of SO2 and Trace SeO2 from Flue Gas: Effect of SO2 on Selenium Capture and Kinetics Study

The effect of SO2 on CaO capture selenium in the flue gas: Density functional theory and experimental study

Insight into As2O3 adsorption characteristics by mineral oxide sorbents: Experimental and DFT study