Abstract:Concerns about arsenic emission issues are growing as the arsenic discharged from coal-fired power plants seriously endangers the ecological environment and public health. The gas-phase arsenic capture by a CaO–Ca12Al14O33 synthetic sorbent at 1000–1200 °C in the simulated flue gas was conducted, with the influence of the addition ratio of Ca12Al14O33, temperature, retention time, and acid gases NO/SO2 considered in the study. The results indicated that the synthetic sorbent containing 15 wt % Ca12Al14O33 (Ca85Al15) exhibited much better arsenic adsorption performance than CaO, which was ascribed to the greatly strengthened sintering resistance of CaO particles by adding Ca12Al14O33, enabling arsenic adsorption and chemical reactions. Both the increasing temperature and retention time facilitated arsenic adsorption by Ca85Al15, and the hypertoxic arsenic vapor (As3+) was converted into arsenate (Ca3(AsO4)2) with less toxicity. In the presence of NO, the arsenic capture was gradually suppressed with increasing retention time. On the other hand, SO2 could slightly facilitate the capture of arsenic at 1000–1100 °C for 10 min; nevertheless, due to the formation of Ca4Al6O12SO4, the promotion effect was inhibited at a higher temperature and a longer retention time. In general, the study provided a basis for developing highly efficient solid sorbents toward controlling arsenic vapor emission derived from coal combustion, and the appropriate conditions for arsenic capture were at 1000–1100 °C.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03686?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03686</a>.Schematic illustration of the preparation procedure to synthesize CaO–Ca12Al14O33 (Figure S1) and diagrams of the adsorption–desorption isotherms of Ca85Al15 and pore-size distribution curves of CaO and synthetic sorbents with different CaO/Ca12Al14O33 ratios based on BJH adsorption data (Figure S2) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03686/suppl_file/ef0c03686_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

In-Furnace Control of Arsenic Vapor Emissions Using Fe 2 O 3 Microspheres with Good Sintering Resistance

Microscopic Spherical α-Fe 2 O 3 for Highly Efficient Gaseous Arsenic Capture in Simulated Flue Gas Under a Wide Temperature Range

Microscopic Spherical Α-Fe2o3 for Highly Efficient Gaseous Arsenic Capture in Simulated Flue Gas under a Wide Temperature Range

As2O3 capture from incineration flue gas by Fe2O3-modified porous carbon: Experimental and DFT insights

Capture gaseous arsenic in flue gas by amorphous iron manganese oxides with high SO2 resistance

Synergistic effects of Fe-Mn binary oxide for gaseous arsenic removal in flue gas

Insight into High Temperature Gas-Phase Arsenic Capture by a CaO–Ca 12 Al 14 O 33 Synthetic Sorbent

Stable and Efficient As2O3 Removal from Simulated Flue Gas Using Al2O3/CaSiO3 Prepared by Anhydrous Grinding and Calcination Method

Experiment and mechanism research on gas-phase As2O3 adsorption of Fe2O3/γ-Al2O3

Fe-Ni bimetallic adsorbent for efficient As 2 O 3 removal from coal-fired flue gas under a wide temperature range: Experimental and DFT study

Controllable synthesis of hierarchical porous Fe3O4 particles mediated by poly(diallyldimethylammonium chloride) and their application in arsenic removal.

Deep insight into the effect of NaCl/HCl/SO2/CO2 in simulated flue gas on gas-phase arsenic adsorption over mineral oxide sorbents

Formation of active Fe(OH)3 in situ for enhancing arsenic removal from water by the oxidation of Fe(II) in air with the presence of CaCO3

Re-using of coal-fired fly ash for arsenic vapors in-situ retention before SCR catalyst: Experiments and mechanisms

Capture of arsenic in coal combustion flue gas at high temperature in the presence of CaSiO3 with good anti-sintering

Gaseous Arsenic Capture in Flue Gas by CuCl 2 -Modified Halloysite Nanotube Composites with High-Temperature NO x and SO x Resistance

Unraveling the capture mechanism of gaseous As2O3 over H-ZSM-5 zeolite from coal-fired flue gas: Experimental and theoretical insights

Chemically bonded zirconium oxide into CaO-based high-temperature coal-fired flue gas As 2 O 3 absorbents for enhanced anti-sintering properties: Experimental and DFT study

Experimental and theoretical study of arsenic removal by porous carbon from MSW incineration flue gas

Study on the Chemical Adsorption of Gaseous As2O3 by Ash

FeS x @MOF-808 composite for efficient As(III) removal from wastewater: behavior and mechanism