Abstract:Concerns about arsenic emission issues are growing as the arsenic discharged from coal-fired power plants seriously endangers the ecological environment and public health. The gas-phase arsenic capture by a CaO–Ca12Al14O33 synthetic sorbent at 1000–1200 °C in the simulated flue gas was conducted, with the influence of the addition ratio of Ca12Al14O33, temperature, retention time, and acid gases NO/SO2 considered in the study. The results indicated that the synthetic sorbent containing 15 wt % Ca12Al14O33 (Ca85Al15) exhibited much better arsenic adsorption performance than CaO, which was ascribed to the greatly strengthened sintering resistance of CaO particles by adding Ca12Al14O33, enabling arsenic adsorption and chemical reactions. Both the increasing temperature and retention time facilitated arsenic adsorption by Ca85Al15, and the hypertoxic arsenic vapor (As3+) was converted into arsenate (Ca3(AsO4)2) with less toxicity. In the presence of NO, the arsenic capture was gradually suppressed with increasing retention time. On the other hand, SO2 could slightly facilitate the capture of arsenic at 1000–1100 °C for 10 min; nevertheless, due to the formation of Ca4Al6O12SO4, the promotion effect was inhibited at a higher temperature and a longer retention time. In general, the study provided a basis for developing highly efficient solid sorbents toward controlling arsenic vapor emission derived from coal combustion, and the appropriate conditions for arsenic capture were at 1000–1100 °C.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03686?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03686</a>.Schematic illustration of the preparation procedure to synthesize CaO–Ca12Al14O33 (Figure S1) and diagrams of the adsorption–desorption isotherms of Ca85Al15 and pore-size distribution curves of CaO and synthetic sorbents with different CaO/Ca12Al14O33 ratios based on BJH adsorption data (Figure S2) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03686/suppl_file/ef0c03686_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Role of CO 2 on trace arsenic and selenium separation from coal-fired flue gas by CaO

Experimental and Density Functional Theory Study of the Adsorption Characteristics of CaO for SeO2 in Simulated Flue Gas and the Effect of CO2

Experimental and Density Functional Theory Study of the Adsorption Characteristics of CaO for SeO 2 in Simulated Flue Gas and the Effect of CO 2

Effect of CO_2 on Trace Selenium Adsorption by CaO from Flue Gas

Simultaneous Removal of So2 and Trace As2o3 from Flue Gas: Mechanism, Kinetics Study, and Effect of Main Gases on Arsenic Capture

Deep insight into the effect of NaCl/HCl/SO2/CO2 in simulated flue gas on gas-phase arsenic adsorption over mineral oxide sorbents

The effect of SO2 on CaO capture selenium in the flue gas: Density functional theory and experimental study

The role of SO2 in arsenic removal by carbon-based sorbents: A DFT study

Insight into the role of SO 2 on selenium conversion during adsorption by CaO: Theoretical calculation and experimental study

Density Functional Theory Study of Steam Effect on SeO<sub>2</sub> Capture by CaO Adsorbents

Effects of CO and CO2 on the Removal of Elemental Mercury over Carbonaceous Surfaces

Simultaneous Removal of SO2 and Trace SeO2 from Flue Gas: Effect of SO2 on Selenium Capture and Kinetics Study

Simultaneous Removal of SO2 and Trace SeO2 from Flue Gas: Effect of Product Layer on Mass Transfer.

Simultaneous Removal of SO<sub>2</sub>and Trace SeO<sub>2</sub>from Flue Gas: Effect of Product Layer on Mass Transfer

Experimental study on simultaneous removal of sulfur and trace selenium element

Seo2 Adsorption on Cao Surface: Dft Study on the Adsorption of A Single Seo2 Molecule

Stable and Efficient As2O3 Removal from Simulated Flue Gas Using Al2O3/CaSiO3 Prepared by Anhydrous Grinding and Calcination Method

Unraveling the intrinsic mechanism behind the retention of arsenic in the co-gasification of coal and sewage sludge: Focus on the role of Ca and Fe compounds

Theoretical Study of As2O3 Adsorption Mechanisms on CaO Surface

Capture of arsenic in coal combustion flue gas at high temperature in the presence of CaSiO3 with good anti-sintering

Insight into High Temperature Gas-Phase Arsenic Capture by a CaO–Ca 12 Al 14 O 33 Synthetic Sorbent