Abstract:Thermal management has become an important issue to be solved in the miniaturization and weight reduction of electronic equipment, especially in the aerospace field. The doped BaTiO3, as a selfregulating heating material, exhibits an attractive application perspective on the thermal control of electrical devices, resulting from its positive temperature coefficient (PTC) property. However, the Curie temperature of most of the doped BaTiO3 material at present is much higher than the operating temperature of the electrical equipment. On this basis, this paper focuses on the controlling of the Curie temperature and thermal control performance of the BaTiO3-based heating component. The polycrystalline Ba1-xSrxTiO3 was synthesized by solid solution reaction. The Curie temperature is tuned by the content of the strontium element, simultaneously the elements Y and Mn are doped to reduce the room temperature resistivity and improve the PTC effect. The X-ray diffraction demonstrates that the bulk phase of the Ba1-xSrxTiO3 generates in the pre sintering process, while the crystallization of composition has completed during the sintering. Importantly, the Curie temperature of doped Ba1-xSrxTiO3 for x=0.3 with average particle size of 4.86 gm has shifted to around 38 C, beyond that exhibiting a 2.8 -orders magnitude of PTCR jump. Results of the thermal control experiment show that, in contrast to the ordinary resistor heater, the heating element based on the BaTiO3 PTC material can achieve lower equilibrium temperature without any auxiliary control methods. Compared to the traditional thermal control system composed by the ordinary resistor, sensor and controller, the novel thermal control system based on PTC heating unit possesses simple structure, lightweight and excellent reliability.

Effect of gradient distribution of fillers on polymeric PTC thermistors prepared by solution mixing and subsiding method

Fabrication and performance evaluation of the flexible positive temperature coefficient material for self‐regulating thermal control

Research progress on conduction mechanism and factors influencing the performance of polymeric PTC composites

Research and Application of Polymer-Based PTC Composites

Design for strontium-lead titanate based composite thermistor materials via chemical processing

High Performance Hybrid Carbon Fillers/Binary-Polymer Nanocomposites With Remarkably Enhanced Positive Temperature Coefficient Effect Of Resistance

Enhanced positive temperature coefficient behavior of the high-density polyethylene composites with multi-dimensional carbon fillers and their use for temperature-sensing resistors

High Performance Hybrid Carbon Fillers/binary–polymer Nanocomposites with Remarkably Enhanced Positive Temperature Coefficient Effect of Resistance

Studies on Preparation and Thermal Control Behavior of Hybrid Fillers/binary-Polymer Composites with Positive Temperature Coefficient Characteristic

Influence of grain boundaries on the properties of Sr0.4Pb0.6TiO3 thermistors

Ti/NiCu/Ag and Al/NiCu/Ag Thin Film Deposited on Positive Temperature Coefficient (PTC) Thermistor by Direct Current Magnetron Sputtering

A Novel Polymer Composite with Double Positive‐temperature‐coefficient Transitions: Effect of Filler–matrix Interface on the Resistivity–temperature Behavior

Insight into the interface effect and PTC effect on the temperature-adaptive electrical conductivity of epoxy composite

A New Polymer Composite Thermistor Having Double PTC Transitions

The Preparation of Fine-Grained Positive Temperature Coefficient Resistance with Superior Electrical Properties

Study On Thermal Control Behavior By Using Batio3-Based Ptc Materials With Room Temperature Curie Point

Study on the low Curie point positive temperature coefficient (PTC) material based on the conductive model

Designs of conductive polymer composites with exceptional reproducibility of positive temperature coefficient effect: A review

e temperature coe ffi cient behavior of the high-density polyethylene composites with multi-dimensional carbon fi llers and their use for temperature-sensing resistors †

A Study on the Properties of (Y, Mn) Co-Doped Sr0.5Pb0.5TiO3 Thermistors

Regulation of DC Electric Field Distribution Within Insulation Via Positive Temperature Coefficient Material