Abstract:The thermal conversion of waste plastic products can provide a promising solution to the issues of environmental pollution, waste management, and energy needs. However, our present understanding on the thermal reforming of different kinds of plastic wastes mixtures during their co-pyrolysis and co-gasification for syngas production and energy recovery is insufficient. Non-selective urban polypropylene (PP) and polystyrene (PS) waste plastics were chosen for the investigations reported here. Thermal degradation properties of PP and PS as well as their blends in different mass ratios were investigated via thermogravimetric (TG) analysis. Co-pyrolysis and CO 2 -assisted co-gasification of PP-PS blends were then conducted using a fixed-bed reactor at a temperature of 1173 K. Experimental results from the blends were then compared with the weighted value calculated from their component feedstocks to quantify the degree of synergistic effect. TG results showed that the co-treatment of PP and PS enhanced the respective devolatilization process. The co-pyrolysis of PP and PS enhanced their thermal cracking, leading to synergistic increases in the yields of H 2 , light hydrocarbons (HC) and total syngas. In co-gasification, the reforming reaction involving CO 2 was synergistically enhanced, resulting in the increased yields of H 2 and HC. The gasification reactivity of carbon black improved during the co-processing of PP and PS due to the synergistic effect between the two different kinds of plastics. Higher synergistic effects were observed from the plastic mixtures having higher PS content that resulted in increased yield of syngas. Co-gasification of PP-PS blends having 40% PP content (2P3S) exhibited the maximum synergistic effect on H 2 , CO, and total syngas showing increased yields by 88.8%, 77.7%, and 74.2% respectively. The lowest synergistic effect was observed for HC that showed increased yield of only 25.1%. The optimal CO 2 consumption was also observed from the co-gasification of 2P3S. Each gram of 2P3S feedstock consumed approximately 1.80 g of CO 2 to result in highest recovered energy of 27.49 kJ/g and the maximum overall energy efficiency of 43.2%. The results revealed that enhanced thermal cracking and CO 2 reforming reaction, along with the improved reactivity of carbon black were mainly responsible for increased yields of H 2 , HC, CO and total syngas during co-gasification. This study contributes to the fundamental understanding of co-processing of non-separated waste plastics for enhanced syngas production and energy recovery, elucidating the synergistic effect between the various kinds of plastics during their co-pyrolysis and co-gasification.

Exploring Synergistic Interactions between Polystyrene and Polyethylene

Advanced Catalyst Technology for Broad/Bimodal Polyethylene, Achieved by Polymer-Coated Particles Supporting Hybrid Catalyst

Hydrogen-free Upcycling of Polyethylene Waste to Methylated Aromatics over Ni/ZSM-5 under Mild Conditions.

One-Pot Upgrading Polyethylene and CO 2 to Aromatics Via Tandem Catalysis

Sustainable production of aromatics via catalytic pyrolysis of polyolefins towards the carbon cycle for plastics

Polyethylene upcycling to aromatics by pulse pressurized catalytic pyrolysis

Co-hydropyrolysis of Pine and HDPE over Bimetallic Catalysts: Efficient BTEX Production and Process Mechanism Analysis

Catalytic co-pyrolysis of poplar tree and polystyrene with HZSM-5 and Fe/HZSM-5 for production of light aromatic hydrocarbons

CO2 facilitated upcycling of polyolefin plastics to aromatics at low temperature

Improvement of Aromatics Selectivity from Catalytic Pyrolysis of Low-Density Polyethylene with Metal-Modified HZSM-5 in a CO2 Atmosphere

2Supercritical CO2-promoted Degradation of Polystyrene to Aromatic Oils with NiO@C Catalyst

Comparative Study on the Synergistic Co-Pyrolysis of Plastics and Rubber Waste: Thermal Behavior and Product Distributions

Supercritical CO 2 -promoted degradation of polystyrene to aromatic oils with NiO@C catalyst

Upcycling of Polystyrene to Aromatic Polyacids by Tandem Friedel-Crafts and Oxidation Reactions

Upgrading waste plastics to value-added aromatics

Insight into the Synergistic Performance During Ex-Situ Catalytic Co-Pyrolysis of Poplar Sawdust and Polypropylene over Fe-Ni/ZSM-5 for the Enhancement of Aromatics

Catalytic oxidation of polystyrene to aromatic oxygenates over a graphitic carbon nitride catalyst

Mechanism of synergistic effects and kinetic analysis in bamboo-LDPE waste <i>ex</i>-<i>situ</i> catalytic co-pyrolysis for enhanced aromatic hydrocarbon production via CeZrAl and HZSM-5 dual catalyst

Heterogeneous oxidative upcycling of polystyrene plastics to benzoic acid under air conditions

Synergistic effects during co-pyrolysis and co-gasification of polypropylene and polystyrene

Catalytic Co-Pyrolysis of Polycarbonate and Polyethylene/polypropylene Mixtures: Promotion of Oil Deoxygenation and Aromatic Hydrocarbon Formation