Abstract:The increasing demand for high-performance aircraft engines has led to a greater emphasis being placed on advanced sealing coating technologies. Developing long-life, self-lubricating, and wear-resistant coatings is of significant research value. This study focuses on the fabrication of a novel self-lubricating and wear-resistant NiCoCrAlY-Cr2O3-AgMo composite coating. This coating was deposited onto a GH4169 substrate utilizing plasma spraying. Scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM-EDS) and X-ray diffraction (XRD) methods were employed to characterize the elemental composition and microstructure of the fabricated NiCoCrAlY-Cr2O3-AgMo composite coating. Microhardness measurements across the coating cross-section indicated a gradual increase in hardness from the GH4169 substrate to the NiCoCrAlY-Cr2O3-AgMo coating. The average hardness of the GH4169 substrate was 413.92 HV0.2, while the CoNiCrAlY bonding layer region exhibited an average hardness of 467.60 HV0.2. The NiCoCrAlY-Cr2O3-AgMo coating itself demonstrated an average microhardness of 643.22 HV0.2. Room temperature friction tests indicated that the average coefficient of friction (COF) of the GH4169 substrate was 0.665. In contrast, the NiCoCrAlY-Cr2O3-AgMo coating exhibited a significantly lower average COF of 0.16, representing a 75.94% reduction compared to the uncoated GH4169 substrate. High-temperature friction tests were conducted at 400 °C, 500 °C, and 600 °C, indicating average COF values of 0.438, 0.410, and 0.268, respectively, for the NiCoCrAlY-Cr2O3-AgMo coating. Specifically, at 600 °C, the formation of a lubricious NiMoO4 tribofilm on the coating surface was observed. This tribofilm effectively reduced the wear rate of the GH605 pin to 2.78 × 10−6 mm3/N·m, highlighting the potential of the NiCoCrAlY-Cr2O3-AgMo coating to reduce wear in high-temperature sliding contact applications.

Fabrication of In Situ rGO Reinforced Ni-Al Intermetallic Composite Coatings by Low Pressure Cold Spraying with Desired High Temperature Wear Characteristics

Fabrication and performance of Ni-Co-P/Si3N4 electroplated composite coatings on al-si alloys

In-Situ Formation of Ni-Al Intermetallics-Coated Graphite/Al Composite in A Cold-Sprayed Coating and Its High Temperature Tribological Behaviors

Investigation of High Temperature Oxidation Behavior and Tribological Performance on Cold Sprayed Nickel–alumina Composite Coating

High-Temperature Friction and Wear of Ni Alloy-Based Composites Containing Ag/Ag-rGO/Ag-rGO-Ni

Plasma Spraying NiCoCrAlY-Cr2O3-AgMo Coatings: Fabrication and Tribological Mechanisms

Dry Sliding Tribological Behaviors of Electrodeposited Ni-GO/SiC Composite Coating on the 2218 Aluminum Alloy

Microstructural and tribological characterization of NiAl matrix self-lubricating composite coatings by atmospheric plasma spraying

TiO2–ZnO/Ni–5wt.%Al Composite Coatings on GH4169 Superalloys by Atmospheric Plasma Spray Techniques and Theirs Elevated-Temperature Tribological Behavior

Preparation and Properties of Ni–Co–P/nano‐sized Si3N4 Electroless Composite Coatings

Microstructural, mechanical and tribological characteristics of reduced graphene oxide (rGO) reinforced nanostructured Al2O3-13wt. %TiO2 coatings

Influence of Embedded Reduced Graphene Oxide on the Corrosion-Wear Performance of Cold Sprayed Zn-rGO/Al Coating in NaCl Solution

Microstructure and tribo-mechanical properties of APS-sprayed NiAl/Cr2AlC composite coatings with various additions of self-made Cr2AlC

Effects of Ni-5 wt% Al/Bi2O3 addition and heat treatment on mechanical and tribological properties of atmospheric plasma sprayed Al2O3 coating

Microstructure, Mechanical and Tribological Properties of Plasma-Sprayed NiCrAlY-Mo-Ag Coatings from Conventional and Nanostructured Powders

High Temperature Oxidation Behavior of Cold Sprayed Ni-Al2O3 Composite Coating

Wear Properties of Self-Fluxing Ni60A–AlMgB14 Composite Coating Fabricated by Plasma Spraying

Microstructure and Mechanical Properties of Twin-Wire Arc Sprayed Ni-Al Composite Coatings on 6061-T6 Aluminum Alloy Sheet

Microstructure and Wear-Resistant Behaviors of Al2O3-TiO2 Reinforced Ni-based Composite Coating Plasma-Sprayed on 6061 Aluminum Alloy

Microstructure and Wear-Resistant Behaviors of Al2O3-TiO2 2 O 3-Tio 2 Reinforced Ni-based Composite Coating Plasma-Sprayed on 6061 Aluminum Alloy

Investigation on Microstructure and Wear Behavior of the NiAl–TiC–Al2O3 Composite Fabricated by Self-Propagation High-Temperature Synthesis with Extrusion