Microstructure of HVOF-sprayed Ag–BaF2⋅CaF2–Cr3C2–NiCr coating and its tribological behavior in a wide temperature range (25 °C to 800 °C)

Weiming Su,Jiaping Zhang,Jifu Zhang,Kesong Zhou,Shaopeng Niu,Min Liu,Hongliang Dai,Chunming Deng

DOI: https://doi.org/10.1016/j.ceramint.2020.08.199

IF: 5.532

2021-01-01

Ceramics International

Abstract:Ag–BaF2⋅CaF2–Cr3C2–NiCr composite powders were prepared by physically blending commercial BaF2⋅CaF2–Cr3C2–NiCr and Ag powders. Ag–BaF2⋅CaF2–Cr3C2–NiCr composite coatings were deposited on Inconel 718 alloy substrate by high velocity oxy-fuel (HVOF) spraying. The friction and wear behavior of the coatings under dry sliding against Si3N4 balls from 25 °C to 800 °C was evaluated with a ball-on-disk high temperature tribometer. The microstructure and composition of the samples were analyzed by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD) and Raman spectrometer. Results showed that the composite coatings were mainly composed of hard phase of Cr3C2, binder phase of NiCr, high-temperature lubrication phase of fluorides and low-temperature lubrication phase of Ag. The fluorides existed in the forms of both crystal particles and amorphous state, while the silver featured as typical thermally sprayed splats. Due to the high flame temperature, some fluorides have been oxidized to chromates and around 30 wt% of Ag was lost during spraying. In addition, it was found that Ag content had an important influence on the composite coating, and an appropriate dosage of metallic silver could effectively improve the tribological performance of the coating. The generation of AgCrO2 at moderate (500 °C and 650 °C) temperature and BaCrO4 at high temperature (800 °C) could contribute to the decline in friction coefficients and wear rates of Ag–BaF2⋅CaF2–Cr3C2–NiCr coatings.

materials science, ceramics