Abstract:Catalyzed by a phenoxycyclopentylimine ligated zirconium complex/dried methylaluminoxane (dMAO) system at 40 degrees C under 1 atm of ethylene pressure, linear vinyl-terminated polyethylene (PE-ene) with nearly 100% of end-functionality was produced via ethylene polymerization. With high efficiency, hydroxyl-terminated polyethylene (PE-OH) was subsequently prepared via the radical initiated thiol-ene click chemistry between the PE-ene and 2-mercaptoethanol. The PE-OH was then used to react with norbornene-5-carbonyl chloride to synthesize the norbornene-terminated polyethylene macromonomer (PE-NB) through the esterification reaction. The ring-opening metathesis copolymerization (ROMP) of PE-NB and norbornene (NB) with the different feed ratio was conducted in the presence of Grubbs II generation catalyst to produce the polyethylene-based graft copolymers. Both random and block polynorbornene-g-polyethylene graft copolymers (PNB-g-PE) were then obtained with different feeding mode, i.e., the one-batch feeding mode and the sequential feeding mode, respectively. The structures of the graft copolymers were characterized by Fourier transform-infrared and proton nuclear magnetic resonance spectroscopy. The molecular weight and molecular weight distribution of PNB-g-PE were determined by high-temperature gel permeation chromatography; the thermal properties of PNB-g-PE were also tested by differential scanning calorimetry. The conversion of macromonomer was found to be nearly 100% in the random copolymerization of macromonomer and norbornene. The random graft copolymers were obtained with the molecular weight of 1.79 x 10(4) - 3.14 x 10(4) with relatively narrow molecular weight distribution (2.09 - 2.60). The molecular weight of the copolymers decreased gradually with the increase in the feed ratio of PE-NB. The molar fraction of PE in the random copolymers varied from 4.6% to 16.8%, depending on the feed ratio of PE-NB to NB, whereas the molar fraction of PE showed slight influence on the melting point of the PE segments. However, the conversion of macromonomer reached about 80% in the block copolymerization of PE-NB and NB. Due to the steric hindrance, the crystallinity of the graft copolymers slightly decreased in comparison with the corresponding PE precursor.

Olefin-Metathesis-Derived Norbornene-Ethylene-Vinyl Acetate/Vinyl Alcohol Multiblock Copolymers: Impact of the Copolymer Structure on the Gas Permeation Properties

Preparation of Polyethylene-Based Random and Block Graft Copolymers

Preparation Of Polar Ethylene-Norbornene Copolymers By Metallocene Terpolymerization With Triisobutylaluminium-Protected But-3-En-1-Ol

Influence of Chain Microstructure on Ethylene-Norbornene Copolymer Film Properties

Telechelic Carboxyl-Terminated Polynorbornenes and Copolym-ers via Chain-Transfer Ring-Opening Metathesis Polymerization

Nanostructured Poly(l-Lactic Acid)-Poly(ethylene Glycol)-Poly(l-lactic Acid) Triblock Copolymers and Their CO2/O-2 Permselectivity

Nickel and cationic palladium complexes bearing (imino)pyridyl alcohol ligands: Synthesis, characterization and vinyl polymerization of norbornene

The Preparation of Polyolefin Elastomer Functionalized with Polysiloxane and Its Effect in Ethylene-Propylene-diene Monomer/silicon Rubber Blends

CO 2 -separation performance of vinyl-addition polynorbornenes with ester functionalities

The Magic of Spiro‐Epoxy Moiety: An Easy Way to Improve CO2‐Separation Performance of Polymer Membrane

Cross-Linked Metathesis Polynorbornenes Based on Nadimides Bearing Hydrocarbon Substituents: Synthesis and Physicochemical Properties

Homo- and Copolymerization of Norbornene and Styrene with Pd- and Ni-Based Novel Bridged Dinuclear Diimine Complexes and MAO

Synthesis and Post-Polymerization Modification of Polynorbornene Bearing Dibromomaleimide Side Groups

Enhanced mechanical properties of acrylate and 5-vinyl-2-norbornene based ethylene terpolymers: rational design and synthesis using remotely modulated phosphine-sulfonate palladium complexes

Impact Properties of Metallocene-Catalyzed Ethylene-Alpha-Olefin Copolymers

Nmr Spectroscopic Study on Copolymer of Ethylene-Norbornene

Preparation Of Comb-Shaped Polyolefin Elastomers Having Ethylene/1-Octene Copolymer Backbone And Long Chain Polyethylene Branches Via A Tandem Metallocene Catalyst System

Nickel‐ and Palladium‐Catalyzed Copolymerizations of Norbornene with Polar α‐Olefins.

Catalyst-Free and Low-Temperature Terpolymerization in a Single-Component Benzoxazine Resin Containing Both Norbornene and Acetylene Functionalities

Keto-Polyethylenes with Controlled Crystallinity and Materials Properties from Catalytic Ethylene–CO–Norbornene Terpolymerization

Vinyl Polymerization of Norbornene with Dinuclear Diimine Nickel Dichloride/Mao