Abstract:Catalyzed by a phenoxycyclopentylimine ligated zirconium complex/dried methylaluminoxane (dMAO) system at 40 degrees C under 1 atm of ethylene pressure, linear vinyl-terminated polyethylene (PE-ene) with nearly 100% of end-functionality was produced via ethylene polymerization. With high efficiency, hydroxyl-terminated polyethylene (PE-OH) was subsequently prepared via the radical initiated thiol-ene click chemistry between the PE-ene and 2-mercaptoethanol. The PE-OH was then used to react with norbornene-5-carbonyl chloride to synthesize the norbornene-terminated polyethylene macromonomer (PE-NB) through the esterification reaction. The ring-opening metathesis copolymerization (ROMP) of PE-NB and norbornene (NB) with the different feed ratio was conducted in the presence of Grubbs II generation catalyst to produce the polyethylene-based graft copolymers. Both random and block polynorbornene-g-polyethylene graft copolymers (PNB-g-PE) were then obtained with different feeding mode, i.e., the one-batch feeding mode and the sequential feeding mode, respectively. The structures of the graft copolymers were characterized by Fourier transform-infrared and proton nuclear magnetic resonance spectroscopy. The molecular weight and molecular weight distribution of PNB-g-PE were determined by high-temperature gel permeation chromatography; the thermal properties of PNB-g-PE were also tested by differential scanning calorimetry. The conversion of macromonomer was found to be nearly 100% in the random copolymerization of macromonomer and norbornene. The random graft copolymers were obtained with the molecular weight of 1.79 x 10(4) - 3.14 x 10(4) with relatively narrow molecular weight distribution (2.09 - 2.60). The molecular weight of the copolymers decreased gradually with the increase in the feed ratio of PE-NB. The molar fraction of PE in the random copolymers varied from 4.6% to 16.8%, depending on the feed ratio of PE-NB to NB, whereas the molar fraction of PE showed slight influence on the melting point of the PE segments. However, the conversion of macromonomer reached about 80% in the block copolymerization of PE-NB and NB. Due to the steric hindrance, the crystallinity of the graft copolymers slightly decreased in comparison with the corresponding PE precursor.

Telechelic Carboxyl-Terminated Polynorbornenes and Copolym-ers via Chain-Transfer Ring-Opening Metathesis Polymerization

Preparation of Polyethylene-Based Random and Block Graft Copolymers

Facile Access To Carboxyl-Terminated Polybutadiene And Polyethylene From Cis-Polybutadiene Rubber

Nickel and cationic palladium complexes bearing (imino)pyridyl alcohol ligands: Synthesis, characterization and vinyl polymerization of norbornene

Synthesis of Carboxyl-terminated Polyolefins <i>via</i> Metathesis Degradation-hydrogenation of Diene Rubbers

Preparation Of Polar Ethylene-Norbornene Copolymers By Metallocene Terpolymerization With Triisobutylaluminium-Protected But-3-En-1-Ol

Advances in Preparation of Cycloolefin Polymers by Ring-Opening Metathetic Polymerization

Marriage of Ring-Opening Metathesis Polymerization and Thiol-Maleimide Chemistries: Direct Polymerization of Prefunctionalized Monomers or Postpolymerization Modification?

Synthesis and Post-Polymerization Modification of Polynorbornene Bearing Dibromomaleimide Side Groups

Homo- and Copolymerization of Norbornene and Styrene with Pd- and Ni-Based Novel Bridged Dinuclear Diimine Complexes and MAO

Ring-opening metathesis polymerization of norbornene derivatives for multifunctionalized all-optical photorefractive polymers with a non-conjugated main chain

Highly Active Vinyl-Polymerization of Norbornene by [2-Methyl-8-(diphenylphosphino)quinoline]nickel(ii) Dichloride/Methylaluminoxane

One-Pot Synthesis Of Brush-Like Polymers Via Integrated Ring-Opening Metathesis Polymerization And Polymerization Of Amino Acid N-Carboxyanhydrides

Vinyl Polymerization of Norbornene with Dinuclear Diimine Nickel Dichloride/Mao

Studies on Ring-Opening Metathesis Polymerization of Norborene Catalyzed by Hydride Containing Mononuclear Ruthenium Complex

Synthesis Of Polypeptoid-Polycaprolactone-Polytetrahydrofuran Heterograft Molecular Polymer Brushes Via A Combination Of Janus Polymerization And Romp

Aromatic (Co)polycarbonates bearing pendant norbornenyl groups: Synthesis, characterization and post-polymerization modification

Nickel‐ and Palladium‐Catalyzed Copolymerizations of Norbornene with Polar α‐Olefins.

Research progress of norbornene and propylene copolymerization

Synthesis and phase behavior of a polynorbornene‐based molecular brush with dual “jacketing” effects

Hexacyclotetradecenes as Polycyclic Fused exo-Norbornene Monomers: Synthesis of Cyclic Olefin Copolymers via Ti-Catalyzed Controlled Polymerization