Abstract:Introduction Polycrystalline alumina is a critical material in the containment of nuclear reactors, and its stress must be evaluated. Objective The current Vickers fracture residual stress test methods are mainly used for amorphous materials. To realize the preliminary application in engineering practice, exploring suitable stress test methods for polycrystalline alumina and testing the micro-zone stress of 95%Al2O3 in 4J33/ 95%Al2O3brazed joints is necessary. Methods The specimens were loaded with different stress states by pre-stressing tooling, and the stress distribution in the test area was clarified through finite element analysis. Then, Vickers indentation experiments were carried out to count the indentation radius a, the crack length l, and the direction of crack propagation θ. Results With the crack size not exceeding the grain size and the effects of microstructure (intergranular pores, intragranular pores, and grain boundaries) and crystal orientation on the crack projection length reduced, a model was developed for calculating the relationship between the crack projection length and the pre-stress of polycrystalline alumina at low load indentation in Palmqvist, with a maximum absolute deviation of 23.3 MPa and a maximum relative error of 49.7%. The microzone stresses on the ceramic side of 4J33/95% Al2O3brazed joints were characterized. Conclusion The stress detection method based on Vickers indentation cracks proposed in this study provides a new idea for evaluating residual stresses in polycrystalline alumina; however, the universality of this method in polycrystalline alumina with different grain sizes and its applicability in other polycrystalline brittle materials can still be further explored.

In Situ Investigation of Strain Localization in Sintered, Porous Segmented Alumina

Plastic Deformation and Sintering of Alumina under High Pressure

Characterization of deformation and damage process of alumina-based ceramics by DIC technique

In situ studies on temperature‐dependent deformation mechanisms of Al2O3 prepared by spark plasma sintering

In-situ Study of Microstructural Evolution and Local Strain Distribution During Tensile Loading of Near-Micrometre Grain Size Aluminium

Deformation and Fracture of Corundum Ceramics with a Multilevel Pore Structure

Fracture Behavior of a High Pressure Die Casting AlSi10MnMg Alloy with Varied Porosity Levels

Microstructure Evolution During the Sintering of Freeze-Cast Alumina

The Influence of the Volume Fraction of Ceramic Particles on the Plastic Strain Localization and Fracture of Metal Matrix Composites. Computational Analysis

In situ mechanical testing of an Al matrix composite to investigate compressive plasticity and failure on multiple length scales

Fracture Behavior of Porous Si3n4 Ceramics with Random and Aligned Microstructure

A Stress Test Method of Polycrystal 95%al2o3 Based on Vickers Indentation-Induced Cracks

Zero Sintering-Induced Shrinkage of Porous Oxide Ceramics

Intergranular space, specific surface area, grain size distribution and distribution of macro, meso and micropores of multiphase microstructure in active microalloyed multifunctional ceramics

Controlling Porosity and Pore Size Distribution of Alumina Ceramics in Consolidation Forming Process Using Modified Starches

Dual-Scale Porosity Alumina Structures Using Ceramic/Camphene Suspensions Containing Polymer Microspheres

Alumina Porous Ceramics Obtained by Freeze Casting: Structure and Mechanical Behaviour under Compression

Dynamic Response of Ceramic Shell for Titanium Investment Casting under High Strain-Rate SHPB Compression Load

A Study of Interparticulate Strain in a Hot-Extruded SiC P /2014 Al Composite

In-Situ Observation of Fracture Behavior of Ti-Aluminide Multi-Layered Composites Produced by a Hybrid Sintering Process

Strain localization in the Alloy 718 Ni-based superalloy: From room temperature to 650 °C