Abstract:AbstractThe Laue microdiffraction technique was used to investigate the strain field caused by the shot-peening operation and its redistribution after thermal hold or fatigue in a model nickel-based superalloy with an average grain size of 40μm$$40\,{\upmu }\hbox {m}$$. Micrometer and millimeter size mappings showed that the plastic deformation introduced by shot-peening in the whole sample partially relaxes after a thermal exposure at 450∘C$$450^{\circ }\hbox {C}$$ and was fully redistributed by the fatigue of the material, except in the hardened layer close to the sample edge. Diffraction patterns permitted to measure separately the strains related to the average alloy (γ+γ′$$\gamma +\gamma ^{\prime }$$) and to the γ′$$\gamma ^{\prime }$$ phase. No difference was observed between the two deviatoric strain fields. Even if there were small stresses in the inner part of the samples, the sensitivity of the Laue microdiffraction method was large enough to quantitatively characterize the crystal misorientations and the deviatoric strain redistributions. Useful data were provided not only at the grain scale but also at the mesoscopic scale, thus bridging the gap between the sin2ψ$$\hbox {sin}^{2}\psi $$ and Ortner’s methods used to determine residual stresses, respectively, in fine and single-grain microstructures. The obtained results are also of first interest for a quantitative comparison with HR-EBSD measurements in the scanning electron microscope. Energy coupled measurements with an energy-dispersive point detector were also performed to determine the full elastic strain tensors associated with the γ$$\gamma $$ and γ′$$\gamma ^{\prime }$$ phases. We demonstrated that, for Ni-based superalloys, the accuracy on strains and stresses was, respectively, of the order of 1×10-3$$1\times 10^{-3}$$ and 250 MPa for the diagonal components of tensors. The measurements suffered from the 150 eV resolution of the detector which made it difficult to the separate the energies of the γ$$\gamma $$ and γ′$$\gamma ^{\prime }$$ phases. Owing to large crystal misorientations, the microdiffraction technique was not able to determine elastic strains and hardening in the highly deformed layer, where a large amount of plastic strain and a number of defects were accumulated. Some improvements are proposed to overcome these difficulties.

Strain localization in the Alloy 718 Ni-based superalloy: From room temperature to 650 °C

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Temperature Effects on Deformation Substructures and Mechanisms of a Ni-based Single Crystal Superalloy

Influence of Strain Amplitude on Low-Cycle Fatigue Behaviors of a Fourth-Generation Ni-Based Single-Crystal Superalloy at 980 °C

In-Situ Study of High Temperature Tensile Fracture Mechanism of Mar-M247 Alloy

Plastic thermal deformation behavior and microstructure evolution of solid solution strengthened Ni-based superalloy

In-situ SEM study of temperature-dependent tensile behavior of Inconel 718 superalloy

Micro-strain and cyclic slip accumulation in a polycrystalline nickel-based superalloy

Ultra high-temperature deformation in a single crystal superalloy: Meso-scale process simulation and micro-mechanisms

Dynamic Strain Aging and Embrittlement Behavior of IN718 During High-Temperature Deformation

Orientation and temperature dependence of yielding and deformation behavior of a nickel-base single crystal superalloy

Effect of microstructure on temperature dependence of deformation behavior in polycrystalline CoNi-based superalloy

The Dependence of Stress and Strain Rate on the Deformation Behavior of a Ni‐based Single Crystal Superalloy at 1050°C

Temperature dependence of deformation behavior, microstructure evolution and fracture mechanism of Inconel 625 superalloy

Orientation-Dependent Characteristics for Residual Grains During Hot Deformation of Nickel-Based Alloy 925

Microtwinning in the nickel-based superalloy CM247LC during compression tests

The Effect of Strain Rate on the Tensile Deformation Behavior of Single Crystal, Ni-Based Superalloys

High-Temperature Creep Behavior of a Nickel-Based Single-Crystal Superalloy with Small-Angle Deviation from [111] Orientation

Local strain redistribution in a coarse-grained nickel-based superalloy subjected to shot-peening, fatigue or thermal exposure investigated using synchrotron X-ray Laue microdiffraction

Hot deformation behavior and process parameters optimization of GH4738 nickel-based superalloy

Influence of composition and precipitation evolution on damage at grain boundaries in a crept polycrystalline Ni-based superalloy