Abstract:Amorphous mixed titania-tantala coatings are key components of Bragg reflectors in the gravitational wave detectors (GWDs). Attaining the lowest possible values of optical absorption and mechanical losses in the coatings is of paramount importance for GWDs, and this requires a complex optimization of the coating deposition and post-deposition annealing. We present here a systematic investigation of the optical properties and internal friction of amorphous mixed titania-tantala coatings grown by ion beam sputtering. We consider coatings with six different cation mixing ratios and we study them both in the as-deposited and annealed state. By exploiting spectroscopic ellipsometry data and modelling, along with ancillary techniques, we retrieved the dielectric function of the coatings in a wide spectral range. When varying the mixing ratio and performing the annealing we find monotonic trends for most of the aforementioned properties. Remakably, the post-annealing Urbach energy displays a definite minimum for a mixing ratio around 20%, very close to the composition of the coatings showing the lowest optical absorption for GWDs applications. We suggest that the observed minimum in the Urbach energy depends not only on the mixing ratio, but also on the annealing parameters. On the other hand, the minimum coating loss angle was found to be weakly dependent on the considered measurement frequency and to lie within a rather broad range of Ti content, suggesting that the search for an absolute minimum following post-deposition annealing should be rather sought in the study of the best annealing parameters for each specific cation ratio considered. This work constitutes a reference for the optical properties of the amorphous mixed titania-tantala coatings, and highlights the relevance of the Urbach energy in the optimization process of materials for high-performing Bragg reflectors.

In-vacuum measurements of optical scatter versus annealing temperature for amorphous Ta2O5 and TiO2:Ta2O5 thin films

Measurements of Optical Scatter Versus Annealing Temperature for Amorphous Ta2O5 and TiO2:Ta2O5 Thin Films

Annealing Temperature Dependent Microstructure and Optical Properties of HfxTi1-xO2 Thin Films

Imaging Scatterometer for Observing In-Situ Changes to Optical Coatings During Air Annealing

Effects of mixing and annealing on the optical and mechanical properties of TiO$_{2}$:Ta$_{2}$O$_{5}$ amorphous coatings

Structure and morphology of low mechanical loss TiO$_2$-doped Ta$_2$O$_5$

Reduction of mechanical losses in ion-beam sputtered tantalum oxide thin films via partial crystallization

Low mechanical loss and high refractive index in amorphous films grown by magnetron sputtering

Amorphous optical coatings of present gravitational-wave interferometers

Medium range structural order in amorphous tantala spatially resolved with changes to atomic structure by thermal annealing

In Situ Optical Characterizations of the Annealing Effects Upon Sno2: F Films by Spectroscopic Ellipsometry

Monitoring the evolution of optical coatings during thermal annealing with real-time, in situ spectroscopic ellipsometry

Structural evolution of binary oxide nanolaminates with annealing and its impact on room-temperature internal friction

Influence of Annealing Temperature on the Properties of Titanium Oxide Thin Film

Investigation of microstructure evolution in Pt-doped TiO2 thin films deposited by rf magnetron sputtering

Tuning of Electrical and Optical Properties of Tantalum Doped TiO2 Flims Prepared by Sol-gel Method

Reducing optical loss of dual-ion beam sputtered HfO2 films via optimization of coating and annealing parameters

Observation of a Correlation Between Internal friction and Urbach Energy in Amorphous Oxides Thin Films

Annealing effects on the optical and electrochemical properties of tantalum pentoxide films

Effect of heat treatment on mechanical dissipation in Ta$_2$O$_5$ coatings

Comprehensive microstructural and optical characterization of the thermal stability of aluminum-titanium oxynitride thin films after high temperature annealing in air