Abstract:In spite of the advantages of LiNi 0.8 Co 0.1 Mn 0.1 O 2 (NCM811) cathode materials such as high energy density and high capacity, their capacity decay during cycling is still a significant problem, which are mainly due to the internal structural collapse and the surge in interfacial impedance caused by interfacial side reactions. To address these issues, wet chemical methods and annealing treatments were used to create LiV 2 O 4 -coated and V 4+ -doped NCM811 cathode materials. The LiV 2 O 4 coating layer and the doped V 4+ had little effect on the crystal structure of the NCM811, according to X-ray powder diffraction and Rietveld refinement studies. Scanning electron microscopy, energy dispersive spectroscopy, X-ray photoelectron spectroscopy, and transmission electron microscopy data all showed that the LiV 2 O 4 layer was successfully coated on the surface of the spherical particles and some of the V 4+ was successfully introduced into the bulk phase. Thanks to the ion-conducting layer, LiV 2 O 4 , the interfacial impedance was reduced while the Li + diffusion rate was accelerated, and the V 4+ doped into the bulk phase stabilizes the internal structure, significantly increasing the cycling stability and the rate performance of NCM811. In particular, when the coating amount was 0.6 wt%, the initial discharge specific capacity reached 203.5 mAh/g at 2.8–4.3 V at 0.1 C, and the retention rate was 87.6% after 100 cycles, which was 12.1% higher compared to 75.5% of the original sample. And when the rate was raised to 5 C, the original sample's capacity plummeted to only about 100 mAh/g, but the sample with 0.6 wt% of coating was still 140.9 mAh/g. Experiments confirmed that this LiV 2 O 4 coating modification with synergistic V 4+ doping provided an innovative technique for boosting the electrochemical performance of Ni-rich ternary cathode materials.

Revealing the Role of W-Doping in Enhancing the Electrochemical Performance of the LiNi0.6Co0.2Mn0.2O2 Cathode at 4.5 V

W Modification of Nickel-Rich Ternary Cathode Material for Efficient Lithium-Ion Batteries

W doping improves the electrochemical performance of LiNi0.94Co0.04Al0.02O2 cathode through dual enhanced electronic and ionic conductivities: A study from DFT calculations and experimental results

Enabling ultra-fast charging for Ni-rich LiNi0.88Co0.09Mn0.03O2 cathode by bulk W-doping

Mitigation of Cation Mixing of LiNiO2-based Cathode Materials by Li-doping for High-Performing Lithium-Ion Battery

Enhancing the Electrochemical Performance of Ni-Rich LiNi0.88Co0.09Al0.03O2 Cathodes through Tungsten-Doping for Lithium-Ion Batteries

Synthesis of LiNi0.9Co0.05Mn0.05O2 and modification with co-doping of Zr4+ and W6+ using acid leaching solution from spent lithium-ion batteries

Enhancing cycle life of LiNi0.95Co0.04Mn0.01O2 cathode by bulk W-doping and surface Co-doping

Investigation of W6+-doped in high-nickel LiNi0.83Co0.11Mn0.06O2 cathode materials for high-performance lithium-ion batteries

Dual-Functional Tungsten Boosted Lithium-Ion Diffusion and Structural Integrity of LiNi 0.8 Co 0.1 Mn 0.1 O 2 Cathodes for High Performance Lithium-Ion Batteries

Enhanced electrochemical performance of LiV2O4-coated and V4+-doped LiNi0.8Co0.1Mn0.1O2 cathode for lithium-ion batteries

Slightly Li-enriched chemistry enabling super stable LiNi0.5Mn0.5O2 cathodes under extreme conditions

Uncovering the Role of Nb Modification in Improving the Structure Stability and Electrochemical Performance of LiNi 0.6 Co 0.2 Mn 0.2 O 2 Cathode Charged at Higher Voltage of 4.5 V

Grain Morphology and Microstructure Control in High‐Stable Ni‐Rich Layered Oxide Cathodes

Atomic Horizons Interpretation on Enhancing Electrochemical Performance of Ni-Rich NCM Cathode via W Doping: Dual Improvements in Electronic and Ionic Conductivities from DFT Calculations and Experimental Confirmation.

Na/W co-doping enhances the electrochemical performance of Li-rich Mn-based cathode through improved electronic conductivity and promoted cationic migration

Enhanced rate performance and mitigated capacity decay of single-crystal LiNi0.8Co0.1Mn0.1O2 by the synergism of Mg doping and V2O5 coating

Stabilizing Ni‐Rich LiNi 0.92 Co 0.06 Al 0.02 O 2 Cathodes by Boracic Polyanion and Tungsten Cation Co‐Doping for High‐Energy Lithium‐Ion Batteries

Integrated co-modification of PO43− polyanion doping and Li2TiO3 coating for Ni-rich layered LiNi0.6Co0.2Mn0.2O2 cathode material of Lithium-Ion batteries

Tungsten and Phosphate Polyanion Co-Doping of Ni-ultrahigh Cathodes Greatly Enhancing Crystal Structure and Interface Stability

Tungsten Boride Stabilized Single‐Crystal LiNi0.83Co0.07Mn0.1O2 Cathode for High Energy Density Lithium‐Ion Batteries: Performance and Mechanisms