Degradation of CMOS APS Image Sensors Induced by Total Ionizing Dose Radiation at Different Dose Rates and Biased Conditions

Wang Zujun,Liu Changju,Ma Yan,Wu Zhijun,Wang Ying,Tang Benqi,Liu Minbo,Liu Zhiyong
DOI: https://doi.org/10.1109/tns.2015.2394779
IF: 1.703
2015-04-01
IEEE Transactions on Nuclear Science
Abstract:The experiments of total ionizing dose radiation effects on CMOS APS image sensors at the dose rates of 50.0 and 0.2 rad(Si)/s were presented. The CMOS APS image sensors were manufactured using the standard $0.35 - \mu \hbox{m}$ CMOS technology that had a typical gate-oxide thickness of 7.0 nm. The samples were divided into two groups, with one group biased and the other unbiased during $^{60}{\rm Co}\gamma$ irradiation. When the samples were exposed to the total dose of 200 krad(Si), only one investigated device was still exposed up to the highest total dose of 800 krad(Si), and functional failure was observed. The dark signal (${K_{\rm D}}$), dark signal non-uniformity (DSNU), noise (${V_{\rm N}}$), saturation output signal voltage (${V_{\rm S}}$), and dynamic range (DR) versus the total doses were investigated. The tendency for $K_{\rm D}$, DSNU, and ${V_{\rm N}}$ to increase at 50.0 rad(Si)/s is larger than that at 0.2 rad(Si)/s. The degradation mechanisms of CMOS APS image sensors were analyzed. The room temperature annealing tests were performed at 24 h, 48 h, and 168 h with different biased conditions after irradiation.
engineering, electrical & electronic,nuclear science & technology
What problem does this paper attempt to address?