Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

Combined Effect of SiO2 and O2 on the Crystallization Behavior of Modified Ti-Bearing Blast Furnace Slag

The Influence of SiO2 on the Extraction of Ti Element from Ti‐bearing Blast Furnace Slag

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

Co-modification and Crystalline-control of Ti-bearing Blast Furnace Slags

Effect of Al2o3 Addition on the Precipitated Phase Transformation in Ti-Bearing Blast Furnace Slags

Influence of Basicity and TiO2 Content on the Precipitation Behavior of the Ti-bearing Blast Furnace Slags

Effect of Al2O3 Addition on the Phase Equilibria Relations of CaO-SiO2-5 Wt%mgo-Al2o3-tio2 System Relevant to Ti-bearing Blast Furnace Slag

Effect of B2O3 on the Melting Temperature and Viscosity of CaO–SiO2–MgO–Al2O3–TiO2–Cr2O3 Slag

Influence of TiO2 on the liquidus temperature and structure of CaO-SiO2-Fe2O3-TiO2 slags

The Effect of P 2 O 5 on the Crystallization Behaviors of Ti-Bearing Blast Furnace Slags Using Single Hot Thermocouple Technique

Precipitation Behaviour of Ti Enriched Phase in Ti Bearing Slag

Improving the Comprehensive Properties of ZrO2–C Materials with Aid of TiO2 Addition

Investigation of the Viscosity and Structural Properties of CaO-SiO 2 -TiO 2 Slags

Polymeric Structure Evolution Behavior Analysis of Aluminosilicate-Based Smelting Slag

Raman spectroscopic study of the structural properties of CaO-MgO-SiO 2-TiO2 slags

Effect of Cr2O3 content on viscosity and phase structure of chromium-containing high-titanium blast furnace slag

Effect of Cr2O3 on Physicochemical Properties of CaO-SiO2-FetO Slags during BOF Smelting Process of Chromium-Bearing Iron

Effect of B 2 O 3 on the Structure and Viscous Behavior of Ti-Bearing Blast Furnace Slags

Investigation on Viscosity and Nonisothermal Crystallization Behavior of P-Bearing Steelmaking Slags with Varying TiO2 Content

Crystallization enhancement and microstructure evolution characteristics of Ti-bearing blast furnace slag glass-ceramics with the introduction of ferrochromium slag

Sulphide capacity of CaO-SiO2-Al2O3-MgO-TiO2-FetO slag with high titanium and high FeO content based on HIsmelt process