Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

Effect of B 2 O 3 on the Structure and Viscous Behavior of Ti-Bearing Blast Furnace Slags

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

Effect of W(mgo)/w(al2o3) Ratio and Basicity on Microstructure and Metallurgical Properties of Blast Furnace Slag

Effect Of P2o5 Addition On The Viscosity And Structure Of Titanium Bearing Blast Furnace Slags

Influence of TiO2, Al2O3, and Basicity on Viscosity and Structure of High Titanium-Bearing Blast Furnace Slag

Influence Of Tio2 And Basicity On Viscosity Of Ti Bearing Slag

Viscosity and structure of MgO–SiO2-based slag melt with varying B2O3 content

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Effect of B2O3 on the Melting Temperature and Viscosity of CaO–SiO2–MgO–Al2O3–TiO2–Cr2O3 Slag

Effect of B2O3 on the viscosity and structure of yellow phosphorus slag melt

Investigation of the Viscosity and Structural Properties of CaO-SiO 2 -TiO 2 Slags

Effect of BaO and MnO on high-temperature properties and structure of blast furnace slag

Role of Na2O and TiO2 on viscosity and structure of Sodium-Titanium-bearing slag

Effect of B2O3 on the structure and properties of aluminate slag

Effect of Al2o3 Addition on the Precipitated Phase Transformation in Ti-Bearing Blast Furnace Slags

Effect of Cr2O3 content on viscosity and phase structure of chromium-containing high-titanium blast furnace slag

Effect of superheat degree and MnO on structural characteristics of CaO-SiO 2 -TiO 2 -based blast furnace slags

The effect of TiO2 on the thermal stability and structure of high acidity slag for mineral wool production

Investigation on Viscosity and Nonisothermal Crystallization Behavior of P-Bearing Steelmaking Slags with Varying TiO2 Content

The Effect of P 2 O 5 on the Crystallization Behaviors of Ti-Bearing Blast Furnace Slags Using Single Hot Thermocouple Technique

Structural Characteristics of CaO-SiO2-Al2O3-FeO Slag with Various FeO Contents Based on Molecular Dynamics Simulations