Abstract:The information of water amount in soil is essential in many fields (e.g. agriculture, forestry, hydrology). Methods to determine water content (WC) can be classified as direct and indirect. Direct methods are connected with the destruction of a sample, are time-consuming and impractical for the measurements in the crop fields. Indirect methods ensure non-destructive and in situ measurements and depend on monitoring a dielectric soil property which is a function of WC. The soil dielectric permittivity is one of the used properties which may be determined by time domain reflectometry (TDR) or frequency domain reflectometry (FDR) techniques. TDR probes are expensive and can be easily damaged at multiple insertions to soil. The open-ended (OE) probes, well-known for their application in the measurements of the complex dielectric permittivity of materials in broadband frequency range, are more resistant to mechanical damage but they are characterized by low penetration depth of electromagnetic waves. Therefore, there is a need to develop sensors able to measure bigger volumes and at the same time sufficiently durable for multiple insertions in soil. &#160;&#160;&#160;&#160;The objective of this work was to test the performance of an open-ended dielectric probe with an antenna (OE-A) in the frequency range 1 MHz &#8211; 6 GHz for two mineral soils using vector network analyzer (VNA) one port (reflective) measurements. Firstly, numerical simulations of the probe using Ansys HFSS software were performed. Secondly, the probe calibration was done on the reference materials (air, distilled water and ethanol). Thirdly, the soils measurements were done to check the possibility to determine soil moisture. &#160;&#160;The obtained results show that the tested probe can be applied for fast moisture measurement with minimal soil disturbance. The real part of dielectric permittivity (&#949;&#8217;) obtained for the tested soils was connected with their moisture and the relation between &#949;&#8217; and volumetric water content was determined. Additionally, the effect of the sample volume was considered and the relation between the high-frequency limit and diameter of the sample was determined. &#160;&#160;&#160;&#160;Acknowledgement:This research was supported by the National Centre for Research and Development (BIOSTRATEG/343547/8/NCBR/2017).

Towards Improved Field Application of Using Distributed Temperature Sensing for Soil Moisture Estimation: A Laboratory Experiment

Improvement and Performance Evaluation of a Dual-Probe Heat Pulse Distributed Temperature Sensing Method Used for Soil Moisture Estimation

A Dual-Probe Heat Pulse Approach Using Heated Fiber-Optic Temperature Sensing

Performance Evaluation of Two Types of Heated Cables for Distributed Temperature Sensing-Based Measurement of Soil Moisture Content

A study of soil thermal conductivity measurement based on the actively heated distributed temperature sensing cable

An Improved Distributed Sensing Method for Monitoring Soil Moisture Profile Using Heated Carbon Fibers

Uncertainties in Measuring Soil Moisture Content with Actively Heated Fiber-Optic Distributed Temperature Sensing

In Situ Soil Moisture and Thermal Properties Estimated Using a Dual-Probe Heat-Pulse

A Distributed Measurement Method for In-Situ Soil Moisture Content by Using Carbon-Fiber Heated Cable

Distributed method for measuring moisture content of soils based on C-DTS

Comparison of Heating Strategies on Soil Water Measurement Using Actively Heated Fiber Optics on Contrasting Textured Soils

Field Test of Two Background Temperature Correction Methods of Dual Probe Heat Pulse Method

DISTRIBUTED FIELD SOIL MOISTURE USING C-AHFO METHOD:LONGTERM MONITORING AND FEASIBILITY

Investigation of the Influence of Soil Moisture on Thermal Response Tests Using Active Distributed Temperature Sensing (A–DTS) Technology

Sensitivity Analysis of Temperature Changes for Determining Thermal Properties of Partially Frozen Soil with a Dual Probe Heat Pulse Sensor

High-Resolution Monitoring of Soil Infiltration Using Distributed Fiber Optic

Use of the Dual-Probe Heat-Pulse Technique to Monitor Soil Water Content in the Vadose Zone

Distributed optical fiber monitoring test and numerical simulation analysis of water-heat coupling process

A modified dielectric probe for increased measurement volume of soil water content

A Self-Calibrated Dual Probe Heat Pulse Sensor for in Situ Calibrating the Probe Spacing

Fiber optic distributed temperature sensing for the determination of air temperature