Abstract:Geothermal energy exhibits considerable development potential in space heating. Shallow geothermal energy stored in the soil in the form of low-grade energy is mainly extracted via the ground source heat pump (GSHP) system. GSHP systems use the subsoil as a heat source, typically involving a vertical borehole heat exchanger (BHE) to extract heat from the formation. Accurate measurement of the thermal properties of the formation is very important for the design of BHEs. At present, the most common and effective method to measure the thermal conductivity of the formation in the field is the thermal response test (TRT). However, the test conditions (heat load, test time) during the thermal response test can impact the test results. Therefore, in this study, a borehole with a depth of 130 m was evaluated in the field. The TRT module and the distributed thermal response test (DTRT) module based on distributed optical fiber temperature sensor (DOFTS) technology were used to monitor the test with different working conditions in real-time. In the field tests, geothermal conditions and the evolution of the formation temperature with time and depth were determined. Based on the test results under different heat loads and test times, the influence of the test conditions on the thermal conductivity results was analyzed and described. A constant temperature zone was located at a depth from 25m to 50 m, and an increasing temperature zone was located at a depth from 50m to 130 m, with a geothermal gradient of 3 °C/100 m. The results showed that the heat load slightly influenced the thermal conductivity test results. At the initial stage of the test, the temperature significantly increased from 0 to 12 h. After reaching the quasi-stable state, the test time slightly influenced the thermal conductivity test results. The characteristics of the formation thermal recovery stage after the test stage were studied. The heat load decreased, which could shorten the time for the formation to recover the initial temperature. The results could provide a basis for the optimization of thermal response test conditions.

A Field Study on the Application of Distributed Temperature Sensing Technology in Thermal Response Tests for Borehole Heat Exchangers

A Case Study of Field Thermal Response Test and Laboratory Test Based on Distributed Optical Fiber Temperature Sensor

Investigation of the Influence of Soil Moisture on Thermal Response Tests Using Active Distributed Temperature Sensing (A–DTS) Technology

Governing Factors for Actively Heated Fiber Optics Based Thermal Response Tests

Distributed Thermal Response Multi-Source Modeling to Evaluate Heterogeneous Subsurface Properties

Actively heated fiber optics based thermal response test: A field demonstration

Influence of Different Heat Loads and Durations on the Field Thermal Response Test

Evaluation of the Long-Term Performance of the Deep U-type Borehole Heat Exchanger on Different Geological Parameters Using the Taguchi Method

Stratified thermal response test measurement and analysis

Field Test and Numerical Simulation on Heat Transfer Performance of Coaxial Borehole Heat Exchanger

Long-term thermal performance analysis of deep coaxial borehole heat exchanger based on field test

An Inversion Method to Estimate the Thermal Properties of Heterogeneous Soil for a Large-Scale Borehole Thermal Energy Storage System

Field test and numerical investigation on deep coaxial borehole heat exchanger based on distributed optical fiber temperature sensor

Laboratory Study on the Thermal Performance of Vertical U‐tube Ground Heat Exchanger During Short‐term Borehole Thermal Energy Storage ( BTES ) and Heat Extraction Process

Experimental Investigation on the Influencing Factors of the Thermal Response Test Using Actively Heated Fiber Optics

Laboratory study on the thermal performance of vertical U‐tube ground heat exchanger during short‐term borehole thermal energy storage ( <scp>BTES</scp> ) and heat extraction process

Effects of groundwater flow on thermal response test of deep borehole heat exchanger

A study of soil thermal conductivity measurement based on the actively heated distributed temperature sensing cable

Estimation of Ground Thermal Properties for Coaxial BHE Through Distributed Thermal Response Test

Calibration and Uncertainty Quantification for Single-Ended Raman-Based Distributed Temperature Sensing: Case Study in a 800 m Deep Coaxial Borehole Heat Exchanger

Introduction of a Thermal Response Test (TRT) Apparatus Used for Measuring Underground Heat Exchanger Characteristics