In Situ Soil Moisture and Thermal Properties Estimated Using a Dual-Probe Heat-Pulse

Jie Liu,Bin Shi,Meng-Ya Sun,Jun-Cheng Yao,Ke Fang

DOI: https://doi.org/10.1016/j.geoderma.2024.117064

IF: 6.1

2024-01-01

Geoderma

Abstract:In situ monitoring of the temporal and spatial distribution of soil moisture and thermal properties are important for studying the water and energy transport in the vadose zone. The single-probe heat-pulse method based on fiber Bragg grating technology (SPHP-FBG) has become a research focus in field monitoring because of its capability to realize quasi-distributed and real-time monitoring. However, the SPHP-FBG method can only obtain thermal conductivity. This study developed a dual-probe heat-pulse method based on FBG (DPHP-FBG). The DPHP-FBG method can measure thermal conductivity (7), volumetric heat capacity (C-v), and thermal diffusivity (k). Consequently, volumetric soil water content (B) can be estimated from its linear relationship with C-v. The accuracy of the DPHP-FBG method in the estimation of C-v, 7 , and B was tested under different heating duration and various soil moisture conditions. In addition, Monte Carlo simulation was performed to investigate the impact of FBG measurement errors on accuracy. Finally, a field test was conducted to verify the effectiveness of the developed DPHP-FBG system. The results show that the DPHP-FBG method allows accurate soil moisture and thermal properties estimation without soil-specific calibration. The mean errors of the C-v and B decrease with the extended heating duration. When the heating lasts 20 s, the measured C-v and B have mean errors of 0.02 MJ m(- 3) K(- 1 )and 0.01 m(3)/m(3), respectively, for various moisture conditions. In the field test, the spatio-temporal distribution of soil moisture and thermal properties can be obtained in real time. Thereby, the proposed DPHP-FBG monitoring system is potential to conduct in situ coupled heat and soil moisture measurements at a large scale.