Abstract:This paper describes a novel three-wire thermal flow sensor for medical applications. The present innovation for low-frequency measurements involves the use of a pulsed-wire anemometer with a comparatively large wire diameter (12.5 microm and larger) together with a novel signal processing approach. A small wire is heated using a sinusoidal alternating current, and two sensing wires, acting as resistance thermometers, are set parallel to, and at a small distance on either side of, the pulsed wire. The thermal wake of the pulsed wire is convected downstream to one of the two receiving wires which detect its delayed arrival. This arrangement allows the sensing of both the direction and the flow velocity component normal to the three probes. By appropriate signal processing, the present sensor can be operated such that the phase shift between the periodic current that drives the central wire and the detected signal by either the upstream or downstream wire takes into account a combination of convection, diffusion and the finite thermal response time of both the pulsed wire and the receiving wire. Because the time constants increase as the flow velocity decreases, the time lag due to thermal inertia supplements the time lag due to the true time of flight, thus yielding an effective operating range of 0.05 m/s <or= U <or= 25 m/s , which corresponds to a dynamic range of 500:1. This wide velocity range is an order of magnitude larger than that for the traditional time-of-flight pulsed-wire anemometers. An important application of the bi-directional thermal flowmeter is the measurement of human respiration, e.g. for early diagnostics of asthmatic attacks. The main advantage of the present sensor is its low sensitivity to variations in temperature and also to the composition of the flowing gas. Also, a calibration will be not needed for each density and gas used in addition to that for velocity. The resultant design work aimed at developing a sensor that can be mass-produced at low cost.

Flow sensor based on the snap-through detection of a curved micromechanical beam

Measuring Flow Velocity Distribution in Microchannels Using Molecular Tracers

Effect of Overheat and Direct Flow Loading on the MEMS Bistable Flow Sensor

Initial approach for all optical type silicon micro-mechanical flow sensor

Bio-inspired flow rate sensor based on optical microfiber embedded soft film

A Transparent Flow Velocity Sensor of Ultra-thin Glass Fabricated by Femtosecond Laser Processing

Piezoresistive snap-through detection for bifurcation-based MEMS sensors

A microcantilever-based gas flow sensor for flow rate and direction detection

Design of Thermal Liquid Flow Microsensor

A Micromachined Single-Crystal Silicon Flow Sensor with a Cantilever Paddle

A MEMS-based Air Flow Sensor with a Free-standing Micro-cantilever Structure

Integrated High-Speed Flow Sensor Based on Pressure Difference Measuring

Design, Simulation and Fabrication of a Micromachined Cantilever-Based Flow Sensor

Design and development of MEMS based beam-membrane structure flow sensor

Bi-directional flow sensor with a wide dynamic range for medical applications

A liquid-metal-based microscale calorimetric in-chip flow sensor for flow rate measuring

A Self-Adaptive Planar Velocity Vector Sensor Based on Vortex-Induced Torsional Swing Motions

Fabrication and characterization of high-sensitivity, wide-range, and flexible MEMS thermal flow velocity sensors

A self-bended piezoresistive microcantilever flow sensor for low flow rate measurement