Abstract:MAX phases demonstrate limited intrinsic resistance to oxidation in oxygen evolution reaction (OER), which hinders the utilization of conductivity in the Mn+1Xn layers and limits their activity. In this study, a strategy is proposed to improve the poor oxidation resistance of MAX phases by finely tuning the elemental composition between the Mn+1Xn layers and the single‐atom‐thick A layers. This approach activates the OER activity through self‐reconstruction. Renewable energy technologies, such as water splitting, heavily depend on the oxygen evolution reaction (OER). Nanolaminated ternary compounds, referred to as MAX phases, show great promise for creating efficient electrocatalysts for OER. However, their limited intrinsic oxidative resistance hinders the utilization of conductivity in Mn+1Xn layers, leading to reduced activity. In this study, a method is proposed to improve the poor inoxidizability of MAX phases by carefully adjusting the elemental composition between Mn+1Xn layers and single‐atom‐thick A layers. The resulting Ta2FeC catalyst demonstrates superior performance compared to conventional Fe/C‐based catalysts with a remarkable record‐low overpotential of 247 mV (@10 mA cm−2) and sustained activity for over 240 h. Notably, during OER processing, the single‐atom‐thick Fe layer undergoes self‐reconstruction and enrichment from the interior of the Ta2FeC MAX phase toward its surface, forming a Ta2FeC@Ta2C@FeOOH heterostructure. Through density functional theory (DFT) calculations, this study has found that the incorporation of Ta2FeC@Ta2C not only enhances the conductivity of FeOOH but also reduces the covalency of Fe─O bonds, thus alleviating the oxidation of Fe3+ and O2−. This implies that the Ta2FeC@Ta2C@FeOOH heterostructure experiences less lattice oxygen loss during the OER process compared to pure FeOOH, leading to significantly improved stability. These results highlight promising avenues for further exploration of MAX phases by strategically engineering M‐ and A‐site engineering through multi‐metal substitution, to develop M2AX@M2X@AOOH‐based catalysts for oxygen evolution.

Effect of oxygen substitution and oxycarbide formation on oxidation of Ti3AlC2 MAX phase

Microstructural and compositional design of Cr2AlC MAX phases and their impact on oxidation resistance

A theoretical investigation of the effect of Ga alloying on thermodynamic stability, electronic-structure, and oxidation resistance of Ti2AlC MAX phase

The Influence of Oxygen Concentration during MAX Phases (Ti3AlC2) Preparation on the α-Al2O3 Microparticles Content and Specific Surface Area of Multilayered MXenes (Ti3C2Tx)

Oxidation mechanism of MAX phases (Ti3AlC2 powders) with and without Sn doping

Oxygen functionalization-induced crossover in the tensile properties of the thinnest 2D Ti<sub>2</sub>C MXene

Effect of Substitutional Oxygen on Properties of Ti3C2Tx MXene Produced Using Recycled TiO2 Source

Mechanical and Oxidation Behavior of Textured Ti2AlC and Ti3AlC2 MAX Phase Materials

Theoretical investigation of the MXene precursors MoxV4-xAlC3 (0 ≤ x ≤ 4)

Microstructure and Oxidation Behaviors of (TiVCr)2AlC MAX-Phase Coatings Prepared by Magnetron Sputtering

Synthesis of MAX Phases in the Ti2AlC–V2AlC System as Precursors of Heterometallic MXenes Ti2 – xVxC

Porous Ti3AlC2 MAX phase enables efficient synthesis of Ti3C2Tx MXene

Molten salt-shielded solid-state synthesis (MS5) reaction-driven >99% pure Ti3AlC2 MAX phase: effect of MAX phase purity on the interlayer separation of MXenes and Na-ion storage

High temperature oxidation behavior of disordered (Ti0.5Zr0.5)2AlC MAX phase via a Machine Learning-Augmented DFT Approach

Local chemical bonding and structural properties in Ti3AlC2 MAX phase and Ti3C2Tx MXene probed by Ti 1s X-ray absorption spectroscopy

Synthesis and Reaction Path of Ti‐Al‐C MAX Phase by Reaction with Ti‐Al Intermetallic Compounds and TiC

Oxidation mechanism and mechanical properties of substitutional transition metal modified Nb4AlC3: A first-principles density functional theory study

Effect of Sn Doping Concentration on the Oxidation of Al-containing MAX Phase (ti3alc2) Combining Simulation with Experiment

Synthesis and electromagnetic wave absorption performances of a novel (Mo0.25Cr0.25Ti0.25V0.25)3AlC2 high-entropy MAX phase

Preparation and performance of MAX phase Ti3AlC2 by in-situ reaction of Ti-Al-C system

Extraordinary Structural Reconstruction of Nanolaminated Ta2FeC MAX Phase for Enhanced Oxygen Evolution Performance