Abstract:This study presented the UV‐initiated methods to graft polyacrylamide (PAM) hydrogel on the surface of polyester (PET) fibers toward the one‐step and the two‐step methods. The results of the study indicate that PAM hydrogels can enhance the hydrophilic property of PET fibers. Additionally, the modified PET fibers exhibit the swelling properties. It is widely recognized that polyester (PET) fibers with swelling properties are necessary for advanced applications of PET fibers in waterproof fabrics. This study presented the UV‐initiated methods to graft polyacrylamide (PAM) hydrogel on the surface of PET fibers. In the one‐step method, PET fibers are impregnated with a mixed solution of the photoinitiator benzophenone (BP) and the monomer acrylalkylamine (AM). Then, the PET fiber was directly exposed to UV light. In the two‐step method, PET fibers were first impregnated with a photoinitiator solution to generate BP radicals. Then, the fibers impregnated with a monomer solution before being grafted by UV light. Both two methods ultimately achieve PAM gelation‐modified PET fibers. The chemical composition and surface structure were detected by Fourier transform infrared spectroscopy and scanning electron microscope. The findings demonstrate that the PAM hydrogel was successfully grafted on the PET fibers through one‐step method or a two‐step method. In addition, the properties of the grafted PET fibers were evaluated by grafting yield, contact angle, and swelling test. The study indicated that the modified PET fibers via a two‐step method exhibited a superior grafting yield up to 29.3% (PET‐2n) and 54% (PET‐2) compared to the one‐step technique (PET‐1). It was shown that the grafting efficacy of PET fibers modified by two‐step method is better than one‐step method. The static contact angles of PET fibers by UV‐Induced were all reduced. For instance, the contact angles of PET‐2n were decreased from 115° to 62.9°; and the two‐step modified PET fiber after acetone cleaning (PET‐2) decreased from 115° to 60°. It was suggested that the hydrophilicity of the modified PET fibers significantly increased. In addition, the research shows that the gelation‐modified fibers were all possessed swelling properties.

Low Temperature Plasma Initiated Grafting Modification on PET Fabrics

Improving the Hydrophilicity of Poly(vinylidene Fluoride) Porous Membranes by Electron Beam Initiated Surface Grafting of AA/SSS Binary Monomers

Surface Modification of Poly(tetrafluoroethylene) Films Via Plasma Treatment and Graft Copolymerization of Acrylic Acid

Preparation and properties of polyester fibers with polyacrylamide hydrogel grafted by UV‐irradiation

Modification of Amorphous Poly(ethylene Terephthalate) Surface by UV Light and Plasma for Fabrication of an Electrophoresis Chip with an Integrated Gold Microelectrode

Anti-dripping PET Fabrics Prepared by Two Steps Radiation-induced Grafting

Radiation Grafting of Glycidyl Methacrylate and Divinylbenzene Onto Polyethylene Terephthalate Fabrics for Improving Anti-Dripping Performance

Roll-to-roll atmospheric plasma treatment: a green and efficient process to improve the hydrophilicity of a PET surface.

Preparation of New Hydrophilic PET Fiber by Grafting with Acrylic Acid and Modification with Amino Groups for Improvement of Dyeing Ability

Surface modification of low temperature plasma-pretreated ePTFE film by AAc graft copolymerization

The graft modification of poly acrylonitrile(PAN) membranes in NVP aqueous solution by low-temperature plasma

Modifying terylene/cotton blend fabric with P(AMPS/NIPA) intelligent hydrogel by graft polymerization initiated with MLTP

Atmospheric Plasma Technique Assessment for the Development of a Polyfunctional End-use Polyester Fabric

Surface Modification and Adhesion Improvement of Expanded Poly(tetrafluoroethylene) Films by Plasma Graft Polymerization

Plasma graft polymerization of Acrylic Acid and immobilization of Heparin to improve blood compatibility of Polyethylene terephthalate (PET).

Effects of Components of Plasma on Hydrophilicity Surface Modification of PET Film

Zeta Potential and Surface Physico-chemical Properties of Atmospheric Air-plasma-treated Polyester Fabrics

Durable and recoverable hydrophilicity of polyethylene terephthalate fabric prepared with plasma selective etching

Low-temperature plasma modification of polyvinylidene fluoride (PVDF) membrane by graft of styrene in gas

PVA Hydrogel Functionalization via PET-RAFT Grafting with Glycidyl Methacrylate and Immobilization with 2-Hydroxypropyltrimethyl Ammonium Chloride Chitosan via Ring-Open Reaction

Study on Hydrophilicity of Polymer Surfaces Improved by Plasma Treatment