Abstract:This paper presents a multi-gain radio frequency (RF) front-end low noise amplifier (LNA) utilizing a multi-core based on the source degeneration topology. The LNA can cover a wide range of input and output frequency matching by using a receiver (RX) switch at the input and a capacitor bank at the output of the LNA. In the proposed architecture here, to avoid the saturation of RX chain, 12 gain steps including positive, 0 dB, and negative power gains are controlled by a mobile industry processor interface (MIPI). The multi-core architecture offers the ability to control the power consumption over different gain steps. In order to avoid the phase discontinuity, the negative gain steps are provided using an active amplification and T-type attenuation path that keeps the phase discontinuity below ±5 degrees between two adjacent power gain steps. Using the multi-core structure, the power consumption is optimized in different power gains. The structure is enhanced with the adaptive variable cores and reactance parameters to maintain different power consumption for different gain steps and remain the output matching in an acceptable operating range. Furthermore, auxiliary linearization circuitries are added to improve the input third intercept point (IIP3) performance of the LNA. The chip is fabricated in 65 nm complementary metal-oxide semiconductor (CMOS) silicon on insulator (SOI) process and the die area is 0.308 mm2. The proposed architecture achieves the IIP3 performance of -10.2 dBm and 8.6 dBm in the highest and lowest power gains, which are 20.5 dB and -11 dB, respectively. It offers the noise figure (NF) performance of 1.15 dB in the highest power gain while it reaches 14 dB when the power gain is -11 dB. The LNA consumes 16.8 mA and 1.33 mA current from a 1 V power supply that is provided by an on-chip low-dropout (LDO) when it operates at the highest and lowest gains, respectively.

A g /I -Based Low-Power LNA for Ka-Band Applications

Design of a Broadband Ka-band MMIC LNA Using Deep Negative Feedback Loop.

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

Design of 25-32 GHz Low Noise Amplifier in a 55nm CMOS Silicon-on-insulator Technology

A 2-V 1.4-dB NF GaAs MMIC LNA for K-Band Applications

Design of Ka band Low Noise Amplifier Based on 65nm CMOS Technology

A 22–33-GHz $G_{m}$-Boosting Low-Power Noise-Canceling LNA in 40-nm CMOS Process

A 18–33 GHz CMOS LNA with 26.7 dB peak gain and 2.8 dB minimum NF for K/Ka-band applications

A 19–31ghz K/Ka-band Broadband Low Noise Amplifier with High Gain and High Flatness

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

A 26-40Ghz Transformer-coupled LNA with 3.1-3.7 Db Noise Figure in 22nm FD-SOI

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

A Ka-Band Broadband Low Noise Amplifier with Resistive and Inductive Feedback

A 1.8-2.7 GHz Triple-Band Low Noise Amplifier with 31.5 dB Dynamic Range of Power Gain and Adaptive Power Consumption for LTE Application

Millimeter-Wave Low-Noise Amplifier Design in 28-nm Low-Power Digital CMOS

A Low-power, High-gain and Excellent Noise Figure GaN-on-SiC LNA Monolithic Microwave Integrated Circuit (MMIC) operating at Ka-band for 5G/6G Application

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

An Ultra Wide Band LNA with Current Reused Topology in <tex>0.18-\mu \mathrm{m}$</tex> GaAs pHEMT Process

A Low Power Inductorless Wideband LNA With G m Enhancement and Noise Cancellation