Abstract:Quantitative visualization of the full-field stress and strain in porous structures is of significance to reveal the mechanism of the damage and failure of engineering materials. To quantitatively characterize the full-field stresses and strains, optical measurement methods, such as photoelasticity for determining the stress fields, moiré and digital image correlation (DIC) methods for measuring the strain fields, have been developed in previous works. However, it is challenging to combine these methods to measure stress and strain fields simultaneously because the speckles and gratings for strain measurement will disturb the interference fringes in the photoelasticity. In this study, a method incorporating photoelasticity and DIC techniques was developed to determine the stress and strain fields simultaneously in different porous structures which were fabricated by three-dimensional (3D) printed technique. The tested models were printed with a highly transparent, colourless material and the speckles on the front surface of the tested models were printed with a translucent, magenta material. Under compressive loads, the stress fields in these models were obtained based on the photoelastic patterns and the strain fields were determined by DIC method. The results indicate the proposed method can simultaneously determine the full-field stresses and strains and the comparison of the distribution of the principal stress and strain difference and the distribution of the shear stress and strain verified its good accuracy. In addition, the stress and strain distribution in different pore structures were compared and found that the optimal design of the pore distribution can greatly change the concentration of the stress and strain fields.

A comparative study of whole-field stress between digital photoelasticity and infrared radiation testing applied for PMMA

Method to Analyze and Evaluate the Depth Profile of the Three Dimensional Residual Stresses State with X-ray

Acoustoelastic determination of local surface stresses in polymethylmethacrylate

Comparative Study of 2D and 3D Micromechanical Discrete Element Modeling of Indirect Tensile Tests for Asphalt Mixtures

Digital shifting photoelasticity with optical enlarged unwrapping technology for local stress measurement

Determination of the Stress and Strain Fields in Porous Structures by Photoelasticity and Digital Image Correlation Techniques

Real-time Evaluating Temperature-Dependent Interfacial Shear Strength of Thermoplastic Composites Based on Stress Impedance Effect of Magnetic Fibers

Stress Distribution and Variation on Infrared Thermograph and Photoelastic Technique

Residual Stress Measurement of PMMA by Combining Drilling-Hole with Digital Speckle Correlation Method

Determination of the Full-Field Stress and Displacement Using Photoelasticity and Sampling Moiré Method in a 3D-Printed Model

Weibull Statistical Analysis on Tensile Strength of Adhesive Joint in PMMA

Analysis of the Stress Field in Photoelasticity Used to Evaluate the Residual Stresses of a Plastic Injection-Molded Part

Quantification of full-field stress in continuously loaded fractured rocks using 3D printing and digital photoelasticity

Determining the constitutive behavior of nonlinear visco-elastic-plastic PMMA thin films using nanoindentation and finite element simulation

Experimental investigation of interface curing stresses between PMMA and composite using digital speckle correlation method

Study of self-heating and local strain rate in polyamide-6 and short fibre glass/polyamide-6 under tension through synchronised full-field strain and temperature measurements

Shear-compression failure behavior of PMMA at different loading rates

Simultaneous Measurement of Stress-Optic Constant and Stress Field of Transparent Plate by Digital Holographic Interferometry

Measurement of the Energy Release Rate of Compressive Failure in Composites by Combining Infrared Thermography and Digital Image Correlation

Non-destructive mapping of stress, strain and stiffness of thin elastically deformed materials

Experimental and Finite Elemental Investigations on Residual Stress of TSV